Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Maintenance (continued)
WARNING: To reduce the risk of
thrown blades and other cutter
head parts make sure the knife
lock bar containing the seven
knife lock screws is positioned
as shown in the cutter head side
view picture.
9. Push the installed knife in firmly.
Visually check that the knife edge
is parallel to the cutter head slot.
10. Tighten the seven (7) knife locking
screws.
NOTE: Move wrench right to left to
tighten.
11. To rotate the cutter head to the next
knife, release the cutter head lock.
Hold down on the red lock lever
located on the left side and rotate the
cutter head.
12. Release the red lock lever and con-
tinue to rotate the cutter head until it
locks. This should correctly position
the second knife.
Accessories
Do not use any accessory unless you
have received and read complete instruc-
tions for its use.
Wiring Diagram
Black
White
Power Cord
Green
All manuals and user guides at all-guides.com
Switch
Over Load
Grounding Wire
26
13. Repeat procedures 5 through 10 for
the second knife.
14. Check that all knife lock screws are
tight and reinstall the dust chute.
Knife Lock Screws
Power Tool Universal Legset ....... AC9910
Dust Collector .............................. AC8640
Replacement Knives.................... AC8630
Motor Lead
Motor Lead
Knife Lock Bar
Motor
Capítulos
Tabla de contenido
