Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installing the Handwheel Knob
1. Locate the handwheel knob and screw
in the loose parts bag.
2. Use the hex "L" wrench from the tool
box to remove the screw from the cen-
ter of the handwheel and remove the
handwheel from the unit.
3. Place the screw through the back of the
handwheel and secure the screw to the
knob on the front of the handwheel.
4. Place the handwheel back on the ele-
vation shaft and reinstall the screw in
the center of the handwheel.
Alignment (Adjustments)
Extension Assembly Alignment
WARNING: To reduce the risk of
injury from unexpected starting or
electrical shock, do not plug the
thickness planer in. The power
cord must remain unplugged
whenever you are adjusting or
aligning the thickness planer.
NOTE: Align only one extension at a time.
Elevate the motor enough to give a proper
view of the table body and clearance of
the knives.
WARNING: Knives are extremely
sharp and could seriously injure
your hands or arms.
1. Place a straight edge across table body
and over infeed extension as shown.
Adjusting the Thickness Indicator
The elevation indicator is preset at time of
manufacture. To check indicator select a
piece of stock at least 12" long and 3/4"
thick. Set planer to 11/16" and run stock
through planer. Measure wood after plan-
ing and if necessary, loosen screws to
adjust elevation indicator to agree with
measurement.
All manuals and user guides at all-guides.com
16
Screw
M5 x 0.8-10
Loosen locking nut and adjust each
side of the table until the straightedge
touches the outer edge of table exten-
sion. Tighten the locking nuts.
2. Repeat step 1 for outfeed extension.
Planer
Table Body
~
Locking
Straightedge
Table
Extension
Knob
Nut
Capítulos
Tabla de contenido
