Maintenance; Troubleshooting - Num'axes CANICOM 800 Manual De Instrucciones

- It is necessary to replace the battery every two years, even if the unit has not been used for long periods.
- Never leave a discharged battery in the unit: leakage could damage your product.

Maintenance

- Remove the battery from the receiver collar and the remote control if you are not using the appliance
for 3 months or more. The collar will memorize the configuration chosen (coding).
- Keep your unit out of reach of children. It is not a toy for you or your children.
- Avoid cleaning the unit with volatile liquids such as solvents or cleaning fluids. Use a soft cloth and

Troubleshooting

neutral detergent.
- In order to maintain water tightness, we recommend the replacement of the seal located in the receiver
collar every year.
Should your CANICOM 800 / CANICOM 1500 stop working or develop a fault, first read this user's guide
over, then check the batteries (see § Checking/replacing battery of remote control and § Checking
replacing battery of receiver collar) and replace them if necessary and retry. Also check that you are using
the product correctly.
If you encounter any problems, re-code the receiver collar (ref. re-coding procedure).
Re-initialize the system by removing the battery from its housing, then with a metallic tool (e.g.
screwdriver, scissors) touch each of the 2 battery contacts for 2 seconds approximately (ref. Diagram 11).
Insert the battery again: One beep is emitted, indicating the battery is in correct position.
CANICOM 800-1500 INDICE CO8:CANICOM 800-1500
Restart your CANICOM using the remote control.
If the problem persists, contact your distributor.
According to the extent of the malfunction, you may have to return your product for check and repair.
For all repairs, please supply the following:
- the complete product
- the proof of purchase (invoice or sales receipt)
If you omit one of these items, the After Sales Service will have to invoice you for any repair costs incurred.
Gb - 31
All manuals and user guides at all-guides.com
Diagram 11
Reset: connect
the 2 supports of
the battery
29/02/08 6:26 Page 31