Getting Started; Using Your Air Purifier; General Operation; Memory Function - Levoit LV-PUR131 Manual Del Usuario

EN
G E T T I N G S TA R T E D
1. Open the back cover of the air purifier
and remove both filters from their plastic
packaging. [Figure 1.1]
2. Place the Activated Carbon Filter back
into the air purifier, followed by the Fine
Preliminary/True HEPA Combination
Filter. Make sure the pull tabs on both
filters are facing out. [Figure 1.2]
3. Replace the back cover by lining up
the cover's feet with the slots in the
bottom of the housing. Make sure that
the triangular piece at the bottom of
the cover is touching the safety switch.
[Figure 1.3]
4. Push the cover closed.
5. Place the air purifier on a hard,
flat surface. Leave 38 cm / 15 in of
clearance on all sides of the air purifier.
[Figure 1.4]
Note: Do not remove the foam piece
attached to the dust sensor cover
unless instructed by Customer Support.
[Figure 1.5]
Figure 1.1
8
Tabs facing
outward
Figure 1.2
Safety
switch
Figure 1.3
38 cm /
15 in
38 cm /
15 in
Figure 1.4
Figure 1.5
U S I N G YO U R A I R P U R I F I E R

General Operation

1. Press to turn the air purifier
on/off. The air purifier fan will start
automatically at low speed.
2. Optionally, press to increase fan
speed. You can also select Auto or
Sleep Mode, or set a timer.
Note:
• For best results, run the air purifier
at high speed for 15–20 minutes
before using a lower speed or Auto
Mode.
• To effectively clean air, keep
windows closed while the air
purifier is operating.
Sleep Mode
Sleep Mode uses the lowest possible fan
speed to create a quiet environment.
• Press to turn Sleep Mode on/off.
•
Pressing or will also exit Sleep
Mode.

Memory Function

When the air purifier is plugged in, it will
remember its programmed settings while
turned off, and resume those settings when
turned back on.

Automatic Shutoff

As a safety feature, the air purifier will
automatically turn off if the back cover is
removed.
Timer
You can set a timer between 1–12 hours.
• Press repeatedly to choose a time
in increments of 1 hour. When you stop
pressing , the display will flash 3 times
and the timer will start.
• The air purifier will automatically turn off
once the timer is finished.
• To cancel a timer, press repeatedly
until the display reads " -:-- " and flashes
3 times.

Auto Mode

Auto Mode uses the dust sensor inside
the air purifier to adjust the fan speed
automatically based on air quality. For
example, if the air quality is bad, the fan will
automatically be set to high speed.
•
Press to turn Auto Mode on/off.
• Pressing or will also exit Auto
Mode.
Auto Mode Chart
Colour Air Quality Fan Speed
Red Bad High
Yellow Moderate Medium
Green Good Low
Blue Very Good Sleep Mode
EN
9