TFA 35.1150 Instrucciones De Uso página 14

TFA_No. 35.1150_Anleitung 21.09.2018
SEASON – Wireless weather station
• In the display appears: German - DEUTSCH, French – FRANCAIS, Italian - ITALIANO, Spanish - ESPANOL, Dutch – NEDER-
LANDS and English - ENGLISH.
8.1.2 Key tones
• In the setting mode, press the + or – button to activate or deactivate the key tone.
8.1.3 DCF reception
• By default, the DCF reception is activated (ATOMIC ON) and after successful reception of the DCF signal no manual adjust-
ment is necessary.
• Press the + or – button in setting mode if you want to deactivate the DCF reception (ATOMIC OFF).
• Once the DCF time reception is deactivated the clock and date must be manually set. No time zone appears.
8.1.4 Time zone setting
• In the setting mode, press the + or – button to make the time zone correction (-12/+12).
• The time zone correction is needed for countries where the DCF signal can be received but the time zone is different from
the DCF time (e.g. +1=one hour plus).
8.1.5 24- or 12-hour system setting
• In the setting mode you can choose between the 12 - or 24 hour system.
• Press the + or – button.
• In the 12-HR system AM (before noon) or PM (after noon) appears on the display.
8.1.6 Temperature unit setting
• You can change between °C (Celsius) or °F (Fahrenheit) as temperature unit in setting mode.
• Press the + or – button.
8.1.7 Setting of atmospheric pressure unit and value
• You can change between hPa or inHg as atmospheric pressure unit in setting mode. Press the + or – button.
• Confirm the setting with the SET button.
• If you have chosen the relative atmospheric pressure unit, the pressure value flashes. Now enter the value by pressing the
+ or – button.
26
10:15 Uhr Seite 14
SEASON – Wireless weather station
• The relative atmospheric pressure is referred to the sea level's pressure and has to be adjusted first to your local altitude.
Ask for the current atmospheric pressure of your home area (Local weather service, Internet, optician, calibrated instru-
ments in public buildings and airport).
9. Temperature and humidity
9.1 Maximum and minimum values, dew point and heat index
• Press the TEMP button in normal mode.
• You can now get the indoor and outdoor maximum values for the temperature and humidity displayed since the last reset.
• Press the TEMP button again.
• You can now get the indoor and outdoor minimum values for the temperature and humidity displayed since the last reset.
• Press the TEMP button again.
• The outdoor heat index is indicated.
• Press the TEMP button again.
• The current dew point temperature for outdoors is indicated.
• Press the TEMP button once more, to go back to the current values display.
• The device will automatically quit the mode if no button is pressed.
• The maximum and minimum values are automatically reset at midnight.
9.1.1 Heat index
• The heat index is the temperature sensation in combination with humidity.
9.1.2 Dew point
• Warm air can absorb much more water or water vapour than cold air. If the air is cooled continuously at constant absolute
humidity, then the relative humidity will steadily increase up to a maximum of 100%. If the air is cooled further, then the
excess water vapour is extracted from it in the form of water droplets.
• The temperature at which this process starts is called the dew point. The dew point temperature is thus dependent on the
temperature and the relative humidity.
9.2 Trend arrows
• The trend arrows indicate whether the values for outdoor temperature and humidity are currently increasing, steady or
decreasing.
27