DeLonghi P70 Instrucciones Para El Uso página 29

APPLYING THE SEALS
✓ Turn the cooker top upside down.
✓ Spread the longer seal "A" around the
left, rear and right sides as shown in
figure 4.6a.
✓ With a cutter or a scissors cut the
excess seal "C" and retain it for next
use (figure 4.6b).
✓ Spread the seal "B" around the left,
front and right edges of the cooker top
as shown in figure 4.6c.
✓ Spread the seal "C" along the rear
edge of the cooker top as shown in fig-
ure 4.6d. Making sure that the begin-
ning and the end overlap at the seal "B"
(see figure 4.6e).
FASTENING THE
INSTALLATION BRACKETS
✓ Each cooker top is provided with an
installation kit including brackets and
screws for fastening the top to fixture
panels from 2 to 4 cm thick.
✓ Turn the cooker top upside down and
fasten the brackets "F and R" to the
appropriate socket holes, without tigh-
tening the screws "B" for the moment.
✓ Make sure that the brackets are faste-
ned as shown in figures 4.7a, 4.7b and
4.7c.
FASTENING THE COOKER
TOP
✓ Insert the cooker top into the hole and
position it correctly.
✓ Adjust the position of the brackets "F
and R" and tighten screws "B" to block
the cooker top firmly in position.
✓ With a sharp cutter or trimmer knife
trim the excess sealing material
around the edge of the cooker top.
All manuals and user guides at all-guides.com
Fig. 4.6a
seal A
Fig. 4.6e
seal B
seal A
R
Fig. 4.7a
Rear side
seal C
seal A
B
R
Fig. 4.7b
Fig. 4.6b Fig. 4.6c
seal C seal B
seal C
R
F
seal C
Fig. 4.6d
F
Front side
seal A
B
F
Fig. 4.7c
29