EasyWalker QTRO Manual De Instrucciones página 23

All manuals and user guides at all-guides.com
skating.
IMPORTANT: The rods between the rear wheels are not suitable for standing on. This is
unsafe and can damage the EasyWalker QTRO.
Parking brake
IMPORTANT: Ensure that the parking brake is engaged when the EasyWalker QTRO is
stationary.
Push the parking brake at the back of the frame gently downwards with the foot. Ensure
that the sides of the brake fall into the designated recesses on the rear wheels so that
the EasyWalker QTRO cannot move (image 24). To release the brake on the EasyWalker
QTRO, push the brake upwards with the foot (image 4).
Collapsing and opening out
WARNING: Ensure that all the locking devices are engaged before use.
!
You can leave the seat and the sun canopy in place on the EasyWalker QTRO when
collapsing and folding out. If using the EasyWalker carrycot or a car seat these must first
be removed.
Position the front wheels with the wheels swivelled and pull the EasyWalker QTRO
backwards slightly so that the front wheels turn forwards. Engage the parking brake and
turn the sun canopy upwards. Click the red safety catch (located on the right hand side
of the frame) upwards. Standing behind the pushchair, squeeze the unlocking handles on
both sides of the push-bar. Move the push-bar downwards while keeping the unlocking
handles pushed in (image 26 + 27). Close the locking hook on the right hand side of the
frame around the designated pin (image 28).
To open out the EasyWalker QTRO, release the locking hook and pull the EasyWalker
QTRO up by the push-bar. The EasyWalker QTRO will unfold by itself. If you hear a double
click then the EasyWalker QTRO has unfolded correctly. Check whether the red safety
catch on the right hand side of the EasyWalker QTRO is in the locked position.
TIP: The four wheels and bumper bar can be removed to make the folded pushchair more
compact.
Raising the height of the push-bar
Release the left and right black clips on the inside of the push bar (located just under
foam). Move the push-bar to the desired height and lock the clips (image 29).
Setting the suspension
You can modify the EasyWalker QTRO's suspension by tightening or loosening the screw
button under the suspension by the rear wheels (image 30). Ensure that the suspension
settings are the same on both sides of the frame.
Alter position of swivel wheels
Slide the black sliding button (above the swivel wheel) downwards to secure the front
wheel into a fixed position (image 31). The wheel will lock if you now turn it. Slide the
sliding button (above the swivel wheel) upwards to put the front wheel in the swivel
position again (image 32). Ensure that both front wheels always have the same setting.
EN-21