Wireless Remote Controller Kit
11
Emergency Operation
In the event of an emergency shown below, push emergency operation on the signal
receiving part (inside the ceiling panel or indoor unit) for emergency operation.
• The batteries of the remote controller have been exhausted.
• The remote controller is out of order.
• The remote controller has been lost.
1
Start
Push emergency operation.
(When the emergency operation is started at a room temperature of 24°C or more, the air
conditioner enters the cooling mode. When the emergency operation is started at a room
temperature below 24°C, the air conditioner enters the heating mode.)
2
Stop
Push emergency operation once again.
CAUTION
The test run switch in the signal receiving part is used for a test run during the installation
work. Do not use it for other purposes.
13-EN
– 13 –
Owner's Manual
1,2