Communication Ports (Fbus, Bms2 Y Plan) - ECOFOREST ecoSMART e-manager Manual Instalador

2.6. Communication ports (Fieldbus1, BMS2 y pLAN)
The e-manager has three entrances connected to the different communication ports of the controller on the bottom rail.
Communications with the controller are made using the Modbus RTU protocol under the RS485 standard.
Only use shielded three-wire cable. The use of any other cable may cause a malfunction of the installation.
NOTE
The Fieldbus1 port is used to read the electrical parameters and the power balance at the main electrical income. To do this, it is
necessary to wire the aerial connector of the FBus terminal block to the CEM-C20 energy meter of CIRCUTOR (included with your
e-manager) as shown below.
CEM-C20 ENERGY METER
10 7
N
POWER
kWh
LINK
COMS
kvarh
21 22
12 9
All manuals and user guides at all-guides.com
4
13
6
FBus
Figure 2.6. Example FBus connection with energy meter.
Installer manual ecoSMART e-manager
CHiNT
NH4-2-32
POWER
SUPPLY
J16
J10 FBUS1 J11 BMS2 J14 pLAN
J27
J15
pCOOEM+
J25
8 7 6 5
J1 J2 J3 J4
24 Vac
FBus BMS2 pLAN
33
NC
COM
NO
COIL
J17 J18 J19 J20 J21 J22 J23 J24
J28
J29
J26
J5 J6 J7
DI1 DI2 DI3 DI4 DI5 DI6