Tabla de contenido
Idiomas disponibles
Idiomas disponibles
FEATURES
This appliance includes some or all of the following
features:
1. Light mode button (high/medium/off/flash)
2. 20 ultra bright LEDs
3. Flexible rubber groove stand
4. Back cover
5. Back cover screw
6. Magnetic discs (exposed to show details)
7. Battery compartment containing three (3) "AA"
alkaline dry cell batteries (not included)
8. Back cover screw hole
9. Battery strap
10. Light holder (locks light on stand)
11. Magnetic base
12. Attachment bar (for securing the light to the
light holder)
POWER SUPPLY
The unit is powered by three "AA" alkaline dry
cell batteries (not supplied). Unscrew the back
cover screw (counter-clockwise) and remove
the back cover. Gently pull the battery strap to
remove the old batteries. Pull the strap gently so
as not to break it. Insert batteries as described in
compartment, making sure the battery strap is first
replaced beneath the new batteries. Replace and
secure the back cover by screwing the back cover
screw clockwise. Do not be over-tighten.
Note:
Use only "AA" alkaline dry cell batteries in this unit.
Caution! When replacing the "AA" alkaline dry cell
batteries: do not mix old and new batteries. Always
insert batteries correctly with regard to polarity (+
and –), marked on the battery and the equipment.
Remove dead batteries immediately and dispose of
per local codes.
USE
Operating the light
Position the unit by adjusting the flexible stand's
legs or by detaching the light and using the
magnetic discs, as desired. Press the light mode
button on the top of the unit.
• Press once for high intensity.
• Press again for medium intensity.
• Press a third time for to turn the light off.
• Press and hold the light mode button for about
five seconds for flashing LEDs.
SB01ALE_Manual_041012.indd 4-5
ENGLISH
Detaching the light from the flexible
stand
• Slide the attachment bar out of the light holder
groove. Once the light is detached, the magnetic
discs allow you to position it on any metallic
surface.
Attaching the light to the flexible stand
Slide the attachment bar back into the light holder
groove.
Caution! To reduce the risk of product damage:
• When the light is attached using either the flexible
stand or magnetic base, do not shake the light or
the object that it is attached to. Do not attach the
light to any electrical wires or any object that it is
not secure.
• Only use the flexible stand and magnetic discs
for attaching the light. The flexible stand and
magnetic discs are not intended to support
additional weight. Do not attach anything
additional to the light or risk of breakage may
occur.
MAINTENANCE
Never submerge the unit in liquids of any kind. If
the unit gets dirty, gently clean the outer surfaces of
the closed body casing with a soft cloth moistened
with a mild solution of water and detergent.
Except for the batteries, there are no user-
serviceable parts inside. Contact the manufacturer if
any components have become worn or broken.
PROTECTING THE ENVIRONMENT
Correct disposal of this product
This marking indicates that this product should not
be disposed with other household wastes
throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled
waste disposal, recycle it responsibly to promote
the sustainable reuse of material resources. To
return your used device, please use the return and
collection systems or contact the retailer where the
product was purchased.
They can take this product for
environmentally safe recycling.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps
prevent environmental pollution and
reduces the demand for raw materials.
Local regulations may provide for separate
collection of electrical products from the household,
4
ENGLISH
at municipal waste sites or by the retailer when you
purchase a new product.
Batteries
Refer to the Safety Warnings in the front of this
Instruction Manual when selecting and replacing
batteries. Always dispose of used batteries properly.
Warning! To reduce the risk of injury/explosion, do
not expose the unit containing batteries to fire or
intense heat as it may explode.
TECHNICAL DATA
SB01ALE
Work light:
20 bright white LEDs
Power source:
3 "AA" alkaline batteries
(not included)
LIMITED WARRANTY
Manufacturer issues this limited warranty to the
original purchaser of this product. This limited
warranty is not transferable and is only valid
for non-commercial use. Manufacturer warrants
this unit for 2 years from the date of purchase
against defective workmanship or material. It is
the obligation of the purchaser to forward the unit
together with proof of purchase to the manufacturer
or its representative with transportation cost
prepaid. This warranty is void if the unit is abused,
handled carelessly or repaired by anyone other
than manufacturer or its authorized representative.
Manufacturer makes no warranty other than this
limited warranty and expressly excludes any implied
warranty including any warranty for consequential
damages. This is the only expressed limited
warranty and manufacturer neither assumes nor
authorizes anyone to assume or make any other
obligation towards the product other than this limited
warranty.
Baccus Worldwide LLC
Weena 290
3012 NJ Rotterdam or
Postbus 819, 3000 AV Rotterdam
5
4/10/2012 6:43:47 PM
Tabla de contenido
