Installation Instructions; Control Knobs - Franke FHC 604 4C M XS Instrucciones Para El Uso Y La Instalacion

INSTALLATION INSTRUCTIONS

Technical details
MODELS
Voltage
Current
Hi-light plate 1200W
Hi-light plate 1800W
Max power W
Electrical cable
1. Installation (Fig 1)
Installation is the buyer's responsibility. The manufacturer accepts no liability for this service. Any action that the
manufacturer has to take due to an erroneous installation will not be covered by the guarantee.
The flush-mounted cook tops are designed for installation in work tops made of all kinds of material, providing they
can withstand a temperature of 100°C, and are between 25 and 40 mm thick
Fixing the cook top to the unit (Fig 2)
The cook top is fixed to the unit by means of the brackets and accessories provided. Holes are provided in
the bottom of the tray where the tabs (A) are inserted so that you can attach the screws (C) that hold the
brackets (B) in place.
Applying the seal (Fig 3)
Important - The figure below shows how the seal must be attached all around the perimeter.
This cook top has been designed for non-professional, domestic use.
2. Electric connections (Fig 4)
Check the details given on the nameplate situated on the underside of the cook top, then make sure that the rated
mains voltage and power available are suitable for its operation.
Before making the electric connections, check the efficiency of the earthing system. Earthing of the cook top is
compulsory by law. The manufacturer will accept no liability for any personal injury or damage to property deriving
from failure to comply with this requirement.
For models without a plug, fit a standard plug capable of withstanding the specified load on the power cord. The
cord's earthing conductor is colored yellow and green. The plug must be accessible.
If you prefer to make a fixed connection to the mains, insert an all-pole circuit breaker with a breaking gap of at
least 3 mm between the cook top and the mains.
To connect the cook top power cord, loosen and remove the cover on the terminal block in order to access the
contacts inside. Make the connection, blocking the cord in place with the cable clamp provided and then close the
terminal block cover again immediately.
If you have to change the cord, the earthing (yellow / green) conductor must always be 10 mm longer than the line
conductors.
Use only rubber cable type H05RR-F.
DECLARATION OF CONFORMITY. In the parts destined to come into contact with foodstuffs, this appliance is in
accordance with the requirements of the EC directive 89/109 transposed in the Italian Legislative Decree N° 108 of
25/01/92.
CE Appliance conforming to the European directives 89/336/EEC, 93/68/EEC, 73/23/EEC and subsequent
revisions.
INSTRUCTIONS FOR USE
Important: Before cooking with the appliance for the first time, it is important to clean the cook top. Then turn on
all the heating elements, one as a time, with no pan on top, for 5 minutes on the maximum temperature setting.
This will eliminate to the "new smell" and make any humidity that had accumulated on the heating elements
evaporate. This is also essential to ensure that the electronic devices function properly.

CONTROL KNOBS

COOKING ZONES ARE CONTROLLED BY KNOBS CONNECTED TO AN ENERGY REGULATOR NUMBERS 1 TO 6
ARE USED TO INDICATE COOKING SETTINGS, TURNING CLOCKWISE WHERE 1 IS THE MINIMUM SETTING AND
6 THE MAXIMUM SETTING. NUMBER 0 SIGNIFIES THE OFF POSITION.
THE ZONE CONTROLLED BY EACH KNOB IS IDENTIFIED BY THE ADJACENT COOKING ZONE IDENTIFICATION.
1. CONTROL KNOB
2. MAINS INDICATOR LIGHT
All manuals and user guides at all-guides.com
FHC 604 4C M XS
230V
26A
2
2
6.0kW
2
3x2,5 mm
(Fig 5)
5