Eco Gold230V Specifications; Preparatory Steps; Installation; Mounting The Rack - V2 KIT ECOGOLD230 Manual De Instrucciones

SPECIFICATIONS
Gate maximum weight
Power supply
Maximum power
Idling current
Full load current
Capacitor
Gate maximum speed
Maximum thrust
Duty cicle
Pinion
Operation temperature
Weight
Protection
Maximum load on 24 VAC
attachments
Protection fuses

PREPARATORY STEPS

CAREFULLY OBSERVE EUROPEAN REGULATIONS
EN12445 AND EN12453 (WHICH REPLACE UNI 8612).
Always check the following:
• Your gate should have a strong and suitable build;
no wickets should be present on the sliding gate.
• The sliding gate should not tilt excessively during its
entire run.
• The gate should be able to slide freely on its
guiding surface without an excessive friction.
• Install both closing and opening limit switches, in
order to prevent the gate going off the guiding
surface.
• Remove any manual locks.
• Bring power cable ducts near the bottom of the gate
(diameter 20 / 30 mm) and of the external devices
(photocells, flasher, key selector).

INSTALLATION

• Prepare a cement base raised 40 - 50 mm from the
ground on which the metal plate will be fixed.
• Provide a channel for two hoses that will house the
cables in the main hole (A) on the counter-plate.
• Such counter-plate shall be fixed to the ground by
means of four anchors next to the already-made
holes (B).
• Fix the motor on the counter-plate by means of the
bolts (3) and the nuts fitted in the holes (C).
All manuals and user guides at all-guides.com
ECO GOLD230V ECO GOLD127V
kg 600 kg 600
230 VAC 50Hz 120 VAC 60Hz
500 W 500 W
1.6 A 3.2 A
2 A 4 A
16 µF 40 µF
0.16 mt/sec 0.16 mt/sec
480 N 480 N
30% 30%
M4 - Z12 M4 - Z12
- 20°C ÷ + 60°C - 20°C ÷ + 60°C
kg 10 kg 10
IP44 IP44
3 W 3 W
F1 = 5 A F1 = 5 A
F2 = 160 mA F2 = 160 mA
F3 = 250 mA F3 = 250 mA
11
C
B

MOUNTING THE RACK

Release the motor and turn the gate completely open.
Fix all the rack elements to the gate, making sure that
they stand at the same height than the motor pinion.
It is important that the rack be positioned 1 or 2 mm
above the motor pinion, in order to prevent that the
motor be damaged under the weight of the gate.
352 mm
C
A
B