6
6
Using the supplied plastic washers, re-install the factory bolts
over the Tailgate Techliner, with the large diameter of the
washer against the underside of the fastener.
Do not overtighten.
8
8
Remove the backing from the hook and loop and fold Tailgate
TechLiner into place while pressing down frmly. Continue the
process in a clockwise direction.
WARNING:
It is imperative to adhere the Tailgate TechLiner to the tailgate of the truck, as described above. Failure to do so may allow the Tailgate TechLiner
to lift during travel as a result of turbulent airfow. This could cause unsafe conditions for the operator of the vehicle or other vehicles nearby.
NOTE:
Clean your Tailgate TechLiner using mild soap and water, or use our TechCare FloorLiner
(630) 769-1500
weathertech.com/warranty
© 2020 MacNeil IP LLC
7
7
Without shifting its position, bend the Tailgate TechLiner
backward to locate the frst hook and loop location. For
painted surfaces, clean each location that the hook and loop
will occupy with provided alcohol wipes and let dry. For spray-
in bed liners, prep the areas using provided Primer 94 Ampule*
and allow to dry.
*One ampule covers about three hook and loop locations and
dabbing works best.
9
9
Starting at one end, tuck the edge of the Tailgate TechLiner
into the plastic extrusion that you previously installed. Work
your way down the length of the tailgate.
& FloorMat Cleaner and Protector for best results.
™
