Taurus BATEDORA 800 Manual De Instrucciones página 5

power supply
7. Push your ingredients down the food chute using
the food pusher.
8. To start cutting, press and hold the variable speed
control in, should you wish to stop release the vari-
able speed control.
Shredder
1. Put the processor bowl shaft into the center of
processing bowl
2. Place the shredding and slicing disk (either blades
facing down or up) on the processing bowl shaft
3. Fasten the food processor gear housing to the
processing bowl. Turn it to the right (clockwise) until
you hear a click.
4. Connect the motor housing to the food processor
gear housing.
5. Fully unroll the power cord and plug it to a suitable
power supply
6. Push your ingredients down the food chute using
the food pusher. Fill the feeding tube evenly for the
best results.
7. To start shredding, press and hold the variable
speed control in, should you wish to stop release
the variable speed control. When processing large
amounts of ingredients, process small batches sepa-
rately and empty the bowl between batches.
Food processor
1. Insert the processor bowl shaft on the center of
processor bowl
2. Carefully place the chopper blade on the top of the
processor bowl shaft
3. Put all your ingredients inside the processor bowl
4. Fasten the food processor gear housing to the
food processor gear housing. Turn it to the right
(clockwise) until you hear a click.
5. Connect the motor housing to the food processor
gear housing.
6. Fully unroll the power cord and plug it to a suitable
power supply
7. To start processing, press and hold the variable
speed control in, should you wish to stop release the
variable speed control.
912900_IM.indd 5
Mixing blade
1. Put the processing bowl shaft on the center of
processing bowl
2. Insert the kneader plastic blade/ blade into the
processing bowl shaft.
3. Put all your ingredients inside the processing bowl
4. Fasten the food processor gear box to the pro-
cessing bowl. Turn it to the right (clockwise) until
you hear a click. The feeding tube must be in line
with the jar holder.
5. Fully unroll the power cord and plug it to a suitable
power supply
6. To start mixing, press and hold the variable speed
control in, should you wish to stop release the vari-
able speed control.
4. CLEANING:
1. Do not immerse the motor unit, the whisk gear
housing, or the processor bowl shaft unit in water.
2. Unplug the appliance from the main power supply.
3. Press the release buttons on the motor housing to
remove the accessory you used.
4. Disassemble the accessory.
5. To clean the measuring cup and food processor
bowl use water, and not any chemical agent or other
liquid.
6. To clean the motor housing, please only use a dry
cloth. Caution: Never use a wet cloth, or immerse
the motor base in water.
7. Be very careful when cleaning the blades as they
are very sharp.
5. Anomalies and repair
1. Take the appliance to an authorised support centre
if product is damaged or other problems arise.
2. If the connection to the mains has been damaged,
it must be replaced and you should proceed as you
would in the case of damage.
2017/12/14 9:27:33 AM