Safety Notes; Important Notes; Functions - marklin VT 98 Serie Manual De Instrucciones

Safety Notes

• This locomotive is to be used only with an operating
system designed for it (Märklin AC, Märklin Delta,
Märklin Digital, DCC or Märklin Systems).
• Use only switched mode power supply units and transfor-
mers that are designed for your local power system.
• This locomotive must never be supplied with power from
more than one transformer.
• Pay close attention to the safety notes in the
instructions for your operating system.
• The feeder track must be equipped to prevent interference
with radio and television reception, when the locomotive is
to be run in conventional operation. The 74046 interference
suppression set is to be used for this purpose.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
• WARNING! Sharp edges and points required for operation.
• The LEDs in this item correspond to Laser Class 1 according
to Standard EN 60825-1.

Important Notes

• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• The warranty card included with this product specifies the
warranty conditions.
• Disposing: www.maerklin.com/en/imprint.html
14
All manuals and user guides at all-guides.com

Functions

• Recognition of the mode of operation: automatic.
• Mfx technology for the Mobile Station / Central Station.
• Address set at the factory: MM 79 / DCC 03
• Setting the locomotive parameters (address, acceleration/
• Headlights, changing over with the direction of travel.
• Various controllable functions.
• Mode of Operation: Locomotive Engineer
• Additional explanations about the mode of operation can
• Only the train control functions and headlight changeover
Note:
The digital protocol with the most possibilities is the highest
order digital protocol. The sequence of digital protocols in
descending order is:
If two or more digital protocols are recognized in the track,
the decoder automatically takes on the highest value digital
protocol.For example, if mfx & MM are recognized, the mfx
digital protocol is taken on by the decoder. Individual proto-
cols can be deactivated with Parameter CV 50.
Name set at the factory: VT 98 469-2
braking delay (ABV), maximum speed):
with the Control Unit, Mobile Station, Central Station.
be found in the supplemental instructions (included).
feature are available in analog operation.
Priority 1: mfx
Priority 2: DCC
Priority 3: MM