Installation - Alpine CDA-7977 Manual De Operación

Installation

Caution
When you install this unit in your car, do not remove
the Detachable Front Panel.
If the Detachable Front Panel is removed during
installation, you might press too hard and warp the
metal plate that holds it in place.
1
Mounting Sleeve
(Included)
CDA-7977/CDA-7876/CDA-7875/CDA-7873
Slide the mounting sleeve into the dashboard.
2
Hex Nut (M5)
Metal
Mounting
Strap
Ground Lead
Chassis
Reinforce the head unit with the metal mounting
strap (not supplied). Secure the ground lead of the
unit to a clean metal spot using a screw (
attached to the vehicle's chassis.
NOTE
For the screw marked
**
the chosen mounting location.
All manuals and user guides at all-guides.com
Metal plate
Detachable
Front panel
Dashboard
Screw
∗∗
Bolt Stud
∗
CDA-7977/
CDA-7876/
CDA-7875/
CDA-7873
∗
) already
, use an appropriate screw for
Connect each input lead coming from an amplifier or
equalizer to the corresponding output lead coming
from the left rear of the CDA-7977/CDA-7876/CDA-
7875/CDA-7873. Connect all other leads of the CDA-
7977/CDA-7876/CDA-7875/CDA-7873 according to
details described in the CONNECTlONS section.
3
Lock Pin
Slide the CDA-7977/CDA-7876/CDA-7875/CDA-
7873 into the dashboard. When the unit is in place,
make sure the locking pins are fully seated in the
down position. This can be done by pressing firmly in
on the unit while pushing the locking pin down with a
small screwdriver. This ensures that the unit is
properly locked and will not accidentally come out
from the dashboard. Install the Detachable Front
Panel.
Removal
1 Remove the DETACHABLE FRONT PANEL.
2 Use a small screwdriver (or similar tool) to push
the locking pins to the "up" position (see above
drawing). As each pin is unlocked, gently pull out
on the unit to make sure it does not re-lock before
unlocking the second pin.
3 Pull the unit out, keeping it unlocked as you do
so.
<JAPANESE CAR>
CDA-7977/
CDA-7876/
CDA-7875/
CDA-7873
Ground Lead
∗
NOTE
Secure the ground lead of the unit to a clean metal spot
∗
using a screw ( ) already attached to the vehicle's
chassis.
Face Plate
Screws (M5 × 8)
(Included)
Mounting Bracket
29
-EN