Ferm FRS-710 Manual De Instrucciones página 4

GB
• Always remove the plug from the mains
socket before carrying out any work on the
machine.
•
Do not carry the machine by the cable.
• Incorrect handling may damage the
machine. Therefore always comply with the
following instructions.
• Use only sharp saw blades in perfect
condition; replace cracked, distorted or
blunt saw blades immediately.
• Machine should only be switched on with
blade installed
• Select tools, stroke rate and pendulum
actions according to material, Take care to
maintain a constant reed rate.
• Do not attempt to stop the saw blade with
lateral pressure after switching off.
• Only use genuine accessories.
• Always use the correct supply voltage. The
voltage specifications on the rating plate
must correspond with the mains voltage.
Equipment marked with 230 V can also be
connected to 220-240 V.
IMMEDIATELY SWITCH OFF THE MACHINE
WHEN:
• Excessive sparking of the carbon brushes
and verticiliosis in the collector.
• Interruption in the mains plug, mains lead or
mains lead damage.
• Defect switch.
• Smoke or stench of scorched insulation.
ELECTRICAL SAFETY
Always check that the power supply
corresponds to the voltage on the
rating plate.
Your machine is double insulated in
accordance with EN 50144; therefore
no earthwire is required.
Replacing cables or plugs
Immediately throw away old cables or plugs
when they have been replaced by new ones. It
is dangerous to insert the plug of a loose cable
in the wall outlet.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The
minimum conductor size is 1.5 mm
4
RSM1011 Ma # 0810-10.1 FC.indd 4
All manuals and user guides at all-guides.com
.
2
When using a cable reel always unwind the reel
completely.
OPERATION
CHANGING/FITTING THE BLADE
Fig.B
Ensure the machine is unplugged.
• Loosen the grub screw with the 3 mm
hexagon key.
• Insert the saw blade between the stroke rod
and the clamping plate.
• Take care that the securing pin of the
stroke rod engages in the hole of the saw
blade. (Saw blade can not be pulled out).
• Retighten the grub screw.
• When changing the saw blade, take care
that the blade holder is free of material
residue (e.g. wood or metal shavings),
• Before using the saw make sure the saw
blade is secure.
USE
Fig.C
Make sure that the saw blade does not
rest on or touch any objects when the
machine is switched on.
Switching on
• Put the on-off trigger switch (4).
Switching off
• Release the on-off trigger switch.
• The on-off trigger switch can be locked on
for continuous operation by pressing the
trigger lock button whilst pulling the trigger.
• To release the trigger lock, simply pull the
trigger switch again.
SPEED CONTROL
• During operation and whilst the machine
is at rest the stroke rate (speed) can be
selected using the thumbwheel (5). The
stroke rate will remain constant even under
load.
Ferm
10/10/08 4:59:41 PM