Uline H-7606 Manual De Instrucciones página 3

TOP ASSEMBLY
1. To attach tabletop onto frame assembly, place
tabletop on a smooth, non-marring surface with top
side facing down.
2. Rotate assembled frame upside down and line
up two pre-drilled holes on back corners of table
top. Using 22 (24 for 72" table) wood screws and
a drill with a Phillips head drill bit, attach frame to
underside of tabletop. The four screws on the left
and right rear corners will use pre-drilled holes, while
the remaining may need tapping. (See Figure 5)
NOTE: There are additional holes in the
tabletop. These are used for a different product
and do not align with this frame.
NOTE: Wood screws for front and back of frame
are optional and provide more support.
NOTE: If holes in frame assembly and
pre-drilled holes in tabletop do not line
up, loosen frame support bars and line up
holes. Insert screws into pre-drilled holes only.
Re-tighten frame support bars. Insert remaining
wood screws to complete attachment of frame
to tabletop.
Figure 5
Wood
Screw
Wood
Screws
Pre-drilled
holes
Tabletop
PAGE 3 OF 9
ASSEMBLY CONTINUED
Wood
Screws
Pre-drilled
holes
Front
1-800-295-5510
3. For Mobile Tables Only:
Using a 17 mm wrench,
attach casters with
four bolts, flat washers,
lock washers and nuts
included in the caster
pack. Put casters in
locking position.
(See Figure 6)
4. Carefully set table upright and recheck all screws
for tightness.
uline.com
Figure 6
1020 IH-7606