Uline H-7704 Guia De Inicio Rapido

H-7704, H-7705
H-8970
ADJUSTABLE HEIGHT
TRAINING TABLE
TOOLS NEEDED
Phillips Head Drill
Screwdriver
Two Person Assembly
Recommended
NOTE: Count and inspect all pieces before
disposing of any carton or packing materials.
# DESCRIPTION
1 Channel
2 Leg
3 Leg Screw, 6 x 12 mm
4 Side Frame
5 Table Top
6 Wood Screw, 4.8 x 16 mm
7 Lever
8 Foot
9 Foot Screw, 8 x 65 mm
10 Caster
11 Allen Wrench
12 14 mm Wrench
1. Remove the two
plastic protectors
on the sides of the
channel (1).(See
Figure 1)
2. For easier assembly, place channel (1) on a raised
surface, such as a table. Insert metal rod located
inside of channel (1) into the mechanism opening
on the top of the leg (2). Repeat this step on the
opposite side. (See Figure 2)
PAGE 1 OF 9
1-800-295-5510
uline.com
Allen Wrench 14 mm Wrench
(included) (included)
QTY
1
2
16
2
1
18
1
2
8
4
1
1
Figure 1
1
Plastic Protector
ASSEMBLY
Figure 2
2
NOTE: If it is difficult to insert the rod into the
mechanism opening on the top of the leg:
• Align the arrow on the mechanism with
the screw. If metal rod will not insert into
mechanism opening on top of leg, press
center mechanism lever and rotate metal rod
to align arrow with screw on top of metal rod.
(See Figure 2)
• If still experiencing
difficulty inserting
the rod into the
mechanism opening,
slowly press down on
top of leg to turn
mechanism opening.
As opening turns,
push rod into
opening until it is
inserted fully.
(See Figure 3)
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7-9.
Center Mechanism Lever
1
0821 IH-7704
Figure 3