Fanaway ORBIT LD-36 CTC Manual Del Usuario página 9

Fanaway Orbit Installation Instructions
INSTALL THE FAN ASSEMBLY TO THE MOUNTING BRACKET
•
After completing the electrical connection at the mounting bracket terminal block, connect the ceiling fan
wiring via the quick connector plug.
•
NOTE: Ensure the earth wiring is secure and correct, by performing an earthing continuity
test from the fan's accessible metal body back to the earth terminal at the terminal
block on the mounting bracket.
Install the fan assembly to the mounting bracket (Fig.5a):
•
Loosen two canopy screws (1) and remove from the mounting bracket.
•
Loosen two canopy screws with star washer (2) by half thread from the mounting bracket. (For L-shape
slot on canopy to be mounted).
•
Lift the hanging canopy (3) of the fan assembly up to the mounting bracket and let the L-shape slot on
the hanging canopy (3) go through the two canopy screws with star washer (2). (Fig.5b)
•
Turn the hanging canopy (3) until it locks in place at the end section of the L-shape slot, ensure the star
washer are between the hanging canopy (3) and screw head. Secure it by tightening the two canopy
screws with star washer (2).
•
Secure and tighten the canopy screws (1) to the mounting bracket. The hanging canopy (3) shall have 4
screws (1) & (2) in total. Avoid damaging the electrical wiring prepared previously when hanging the
canopy.
Fig. 5b
9 | P a g e
Fig. 5a
1
2
3 - hanging canopy
1
2 – screw with star washer