Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Always wear SAFETY GLASSES
when installing hitch
1.
Clean weldnuts: Remove the any stickers or remove any plugs that may be covering weldnuts on the frame rails, both sides. Make sure weldnuts are free from rust and debris. Use a
M14x1.5 tap to clean the weldnuts if necessary.
2.
Install hitch: Raise the hitch into position and align holes in hitch bracket to the frame rail weldnuts and loosely install the supplied M14 bolts ① and conical washers ② to the
hitch, see Figure 1.
3.
Tighten all M14 fastners with torque wrench to 89 Ft.Lb. (121 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged
should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch. This product complies with safety specifications and requirements for
connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2019 Horizon Global™ Corp - Printed in Mexico
Installation Instructions
PART NUMBERS: 76290, 84290, CQT76290
Frame rails
Fasteners
typical
both sides
Figure 1
①
②
Sheet 3 of 12
76290NP
Fastener Kit: 76290F
Qty. (6)
Bolt M14x1.5x45
CL10.9
Qty. (6)
Conical washer 5/8''
Part #: 01292010
Conical washer
teeth side
against hitch
①②
04-20-19
Rev. A
Tabla de contenido
