Tabla de contenido
Idiomas disponibles
Idiomas disponibles
System Start Up
Step 1
- Turn on water supply at cold water angle stop.
Turn cold water faucet handle to the open position
to start the flow of water through the unit. Run 5
gallons of water through the unit in order to flush
out the normal black carbon fines (it will "sputter"
until the air is purged out) from the unit. A container
with a known volume can be filled to determine how
much water has flushed through the system. Initially,
the water may appear cloudy which is due to tiny air
bubbles and it will clear up shortly. Close the faucet
when finished.
Step 2
- Check for leaks. If you have any leaks, shut off the
water supply to your system, tighten any fittings then
turn the supply back on.
NOTICE
Check frequently over the next 24 hours to ensure no leaks
are present
Product Registration
To Register your product, please visit www.watts.com/pureh2o
and select "Register Now". Watts is concerned for the safety of
your personal information. Watts collects personal information
when you register with Watts. This information is stored in our
data base and we do not rent, sell, or share personal information
with other people or nonaffiliated companies. We will send you
certain types of communications such as direct mail, email, or
by telephone relating to our products or products that you have
purchased only with your prior permission. We limit access to
your personal information to those employees who will directly
provide you with services or products in order to do their jobs.
See our privacy policy at - http://www.watts.com/privacy.asp
See Terms of Use at - http://www.watts.com/terms.asp
Annual Maintenance
Replacement filter: High Capacity Quick Turn
Carbon Filter (12 Months- PN# 88005232)
H2O-F45
To buy replacement part(s) please visit the retail store or their
website or contact Watts retail customer service at
(888) 321-0500
Step 1
- Turn off incoming water supply to the filtration unit.
Step 2
- Open the cold water faucet handle to relieve the
water pressure.
Step 3
- Remove the filter from the head by turning to the left,
then pulling downwards. Discard the old filter.
Step 4
- Remove plastic wrapping and cap from new filter.
Step 5
- To install new filter cartridge, with the filter label facing
approximately 45 degrees to the left, push the filter
into the filter head and twist it to the right until the
filter locks in and the label on filter is facing the front.
Step 6
- Follow start-up procedure.
Step 3
Step 5-1
NOTICE
Tubing not shown in above pictures. Do not remove the tubing
while changing the filter
Page 5
Step 4
Step 5-2
Capítulos
Tabla de contenido
