• Let the appliance cool down for 4 minutes
before you continue processing.
Recipe Example: Mashed Potatoes
2.2 lbs / 1 kg cooked potatoes
7 fl. oz. / 200 ml warm milk
• Place the potatoes in a bowl and mash
for 20 - 30 seconds (3/4 way on the
Smart Speed switch)
• Add the milk. Resume mashing for
another 20 - 30 seconds.
Chopper Accessory (C)
The «ca» chopper (9) is perfectly suited
for chopping meat, hard cheese, onions,
herbs, garlic, vegetables, bread, crackers
and nuts.
For best results of hard food processing
fill the bowl of «ca» chopper (9) with max.
10.5 oz / 300 g. Not suitable for liquids.
Refer to the Processing Guide C for maxi-
mum quantities and recommended speeds.
Before Use
• Pre-cut foods into small pieces for
easier chopping.
• Remove any bones, tendons and gristle
from meat to help prevent damage to
the blades.
• Make sure the anti-slip rubber ring (9d)
is attached to the bottom of the chopper
bowl.
Assembly and Operation
• Carefully remove the plastic cover from
the blade.
• The blade (9b) is very sharp! Always
hold it by the upper plastic part and
handle it carefully.
• Place the blade on the center pin of the
chopper bowl (9c). Press it down and
give it a turn so that it locks into place.
• Fill the chopper with food and put on
the lid (9a).
• Align the chopper with the motor part
(3) and click together.
• To operate the chopper, switch on the
appliance. During processing, hold the
motor part with one hand and the chop-
per bowl with the other.
• Always chop harder foods (e.g. parme-
san cheese) at full speed.
• When chopping is complete, unplug
and press the EasyClick release buttons
to detach the motor part.
• Lift the lid up. Carefully take out the
blade before pouring out the contents
of the bowl. To remove the blade,
slightly turn it then pull it off.
Caution
• Do not use the chopper accessory to
process extremely hard foods, such as
unshelled nuts, ice cubes, coffee
beans, grains, or hard spices e.g.
nutmeg. Processing these foods could
damage the blades.
• If using the appliance to purée hot food,
allow hot food to cool slightly to avoid
risk of scalding.
• Never place the chopper bowl in the
microwave oven.
Care and Cleaning (D)
• Always clean the hand blender and the
suitable accessories thoroughly for first
use and after every use with water and
detergent.
• Unplug hand blender before cleaning.
• Do not immerse the motor part (3) or
the gearbox (6a, 8a) in water or any
other liquid. Clean with a damp cloth only.
• The lid (9a) can be rinsed under run-
ning water. Do not immerse in water,
nor place in a dishwasher.
• All other parts can be cleaned in a dish-
washer. Do not use abrasive cleaners
that could scratch the surface.
• You may remove the anti-slip rubber
rings from the bottom of the bowls for
an extra thorough clean.
• When processing foods with high pig-
ment content (e.g. carrots), the acces-
9