Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
● Keep your fi nger off the trigger except during
fastening operation, because serious injury
could result if the push lever accidentally
contacts you or others in work area.
● Keep hands and body away from the
discharge area. This metabo HPT nailer may
bounce from the recoil of driving a fastener
and unwanted subsequent fastener may be
driven, possibly causing injury.
● Some types of loaded nails can spark out of the
muzzle during a nail driving operation. Exercise
caution!
THE OPTIONAL SEQUENTIAL TRIP MECHANISM
(SINGLE SHOT PARTS) is for use where precision
fastener placement is desired and must be operated in
accordance with the following "Method of Operation".
You must fi rst depress the push lever (upward position)
where you want to drive a nail and then pull the trigger.
After the each nail is driven, completely release the
trigger and lift the tool off the work surface.
An OPTIONAL SEQUENTIAL TRIP MECHANISM
may reduce the possibility of bodily injury to you or
others in the work area. This is because it is less
likely to drive an unwanted nail if you keep the trigger
pulled and accidentally bump the push lever against
yourself or others. An OPTIONAL SEQUENTIAL TRIP
MECHANISM may also reduce the speed of operation
compared to the standard contact trip mechanism.
NOTE:
● Both STANDARD CONTACT TRIP MECHANISM and
OPTIONAL SEQUENTIAL TRIP MECHANISM are
safe if used as described above and accroding to all
warnings and instructions.
● Always handle nails and package carefully. If nails
are dropped, collating wire may be damaged and cut,
which will cause mis-feeding and jamming.
● After nailing:
1) disconnect air hose from the Nailer;
2) remove all nails from the Nailer;
3) supply 5 – 10 drops of metabo HPT pneumatic
tool lubricant into the air plug on the Nailer; and
4) open the petcock on the air compressor tank to
drain any moisture.
USING THE SHINGLE GUIDE
The shingle guide can be used to control shingle spacing.
Adjust the shingle guide in the following order.
1 DISCONNECT AIR HOSE FROM NAILER
2 Loosen the hex. socket hd. bolt with the accessory
Allen wrench.
16
WARNING
3 Place the shingle guide against the bottom of the fi rst
row of shingles.
4 Adjust the distance between the outlet and the
shingle guide to the proper shingle exposure by
sliding the shingle guide.
5 Tighten the hex. socket hd. bolt.
Second Row
Outlet
Proper Shingle
3
Exposure
4
Shingle Guide
Hex. Socket
Hd. Bolt
NOTE:
● The proper shingle exposure will depend on the type
of shingle and the manufacturer's specifi cations.
● The shingle guide is not to be utilized as an indicator
of nail location.
ADJUSTING THE NAILING DEPTH
● Disconnect the air hose from the nailer
before turning the adjuster.
To assure that each nail penetrates to the same depth, be
sure that:
1) the air pressure to the Nailer remains constant
(regulator is installed and working properly), and
2) the Nailer is always held fi rmly against the workpiece.
If nails are driven too deep or shallow into the workpiece,
adjust the nailing in the following order.
1 DISCONNECT AIR HOSE FROM NAILER
Adjuster
First Row
Disconnect
1
air hose
WARNING
15
Disconnect
air hose
Tabla de contenido
