Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ACC908-17L.qxd
21/02/02 18:43
Adjustment of the wall mount
The wall mount is factory adjusted for an installation without tilt. If you wish to adjust the degree of
tilt that the screen should have once installed, you should straight away adjust the position of the
arms on each side of the wall mount. You can mechanically adjust the degree of tilt of the screen to
one of five positions (0°, 5°, 10°, 15° or 20°).
To modify the factory setting, do the following:
1 -
Take out the 2 bolts from each side of the adjustment arm of the wall mount.
2 -
Change the position of the adjustment arm to the desired position by repositioning it using one
of the 5 positioning holes.
3 -
Replace the 2 retaining bolts and tighten correctly. Check that both adjustment arms are set to
the same position and use the same holes.
0˚
20˚
15˚
10˚
5˚
Factory setting
Page 11
All manuals and user guides at all-guides.com
Adjustment bolt
11
20˚
Tilt angle adjustment
arm
Tilt adjustment holes
Screen retainer bar
Personal settings
EN
EN
Tabla de contenido
