Cabling Recommendations; Electrical Power Supply - Adeunis RF ARF33-PRO Guia De Instalacion

Ocultar thumbs Ver también para ARF33-PRO:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Tighten the 2 screws
Slide the gasket along the cable attached to its position in the gland
Tighten the cable into the cable gland with clamping ring (it is not necessary to tighten the ring too much, a
simple stroke of 15mm spanner sufficient to ensure a good seal).

2.1.2 Cabling recommendations

See the following table to complete the connection cable following product configuration
Configuration
RS232/RS485
USB
Connect the cable shield to the GND terminal on this product.
2.2.

Electrical power supply

Recommended voltage: 4.5 to 36V. Do not power the modem with 110 or 220V.
Install your device close to its DC power supply.
For your safety, the electricity supply must be connected with the power switched off.
At 12 V, choose a power supply that can deliver 500 mA.
208504A-V1.2-QUICK_ST_GUIDE
Specificity
Number of wire
Cable shielded
6
Cable shielded
5
Gasket
Clamping ring
Section
0.55mm²
0.22mm²
Terminal
Plastic Cover
Screws
Max Size Cable
6.5mm
6.5mm
GB
14
Tabla de contenido
loading

Este manual también es adecuado para:

Arf43-proArf53-pro

Tabla de contenido