Kichler PINION 60 Manual De Instrucciones página 7

INSTALLING THE TOP HOUSING(continued)
Step 3.
Remove the hanger ball from downrod assembly by loosening set screws ,
removing the cross pin, and sliding ball o the rod.( Fig. 7)
Step 4. Carefully feed the fan wires and safety cable up through the downrod.
Thread the downrod onto the motor coupling until the cross pin holes are
aligned. Next, replace the cross pin and clip, and tighten both set screws. (Fig. 8)
Step 5. Slip the coupling cover, canopy hole cover and canopy onto the
downrod. Carefully reinstall the hanger ball onto the downrod. Make
sure the cross pin is in the correct position and the set screw is tight
and the wires are not twisted . ( Fig. 9)
Cross Pin
Cross Pin
Clip
Downrod
Coupling
Set Screw
Fig. 8
Fig. 9
Hanger Ball
Set Screw
Downrod
Fig. 7
Hanger Ball
Canopy
Canopy Hole
Cover
Coupling Cover
60" PINION 7