Stanley STHT77502 Manual De Instrucciones página 14

E 3. Use the bracket's clamp (Figure
place on a stud, ceiling grid, or pole.
• If necessary, rotate the clamp so it is positioned at the
correct angle for attaching to the object. While holding
the bracket arm with one hand, use your other hand to
turn the clamp (Figure
• Position the bracket's clamp around the stud, ceiling
grid, or pole.
• Turn the clamp knob (Figure
the clamp is tight around the object and the bracket is
held in place.
Using the Laser with Other Accessories
WARNING:
Since accessories other than those offered by
STANLEY have not been tested with this laser, use of
such accessories with this laser could be hazardous.
Only use STANLEY
®
with this model. Accessories that may be suitable for one laser
may create a risk of injury when used with another laser.
The laser is equipped with a 1/4-20 female thread on the
bottom, side, and back (Figure
future STANLEY accessories.
®
Other recommended accessories for use with this laser are
available at extra cost from your local dealer or authorized
service center. If you need assistance locating any accessory,
please contact your nearest STANLEY service center or visit our
website: http://www.STANLEY.com.
Maintenance
• When the laser is not in use, clean the exterior parts with
a damp cloth, wipe the laser with a soft dry cloth to make
sure it is dry, and then store the laser in the kit box provided.
• Although the laser exterior is solvent resistant, NEVER use
solvents to clean the laser.
• Do not store the laser at temperatures below -5 ˚F (-20 ˚C) or
above 140 ˚F (60 ˚C).
• To maintain the accuracy of your work, check the laser often
to make sure it is properly calibrated.
• Calibration checks and other maintenance repairs may be
performed by STANLEY service centers.
14
) to hold the laser in
H 6
).
H 7
) clockwise until
H 8
accessories that are recommended for use
) to accommodate current or
C
Troubleshooting
The Laser Does Not Turn On
• Check the AA batteries to make sure:
• Each battery is installed correctly, according to (+) and (–)
listed inside the battery compartment.
• The battery contacts are clean and free of rust or
corrosion.
• The batteries are new, high-quality, name brand batteries
to reduce the chance of battery leakage.
• Make sure the AA batteries are in proper working condition. If
in doubt, try installing new batteries.
• When using rechargeable batteries, make sure the batteries
are fully charged.
• Be sure to keep the laser dry.
• If the laser unit is heated above 120 ˚F (50 ˚C), the unit will
not turn ON. If the laser has been stored in extremely hot
temperatures, allow it to cool. The laser level will not be
damaged by using the Power/Transport Lock switch before
cooling to its proper operating temperature.
The Laser Beams Flash
When in self-leveling mode, the lasers are designed to self-
level up to an average of 4° in all directions. If the laser is tilted
so much that the internal mechanism cannot level itself (or the
laser is not level when in manual mode), the laser beams will
flash indicating that the tilt range has been exceeded.
THE FLASHING BEAMS CREATED BY THE LASER ARE
NOT LEVEL OR PLUMB AND SHOULD NOT BE USED
FOR DETERMINING OR MARKING LEVEL OR PLUMB. Try
repositioning the laser on a more level surface.
The Laser Beams Will Not Stop Moving
The laser is a precision instrument. Therefore, if it is not
positioned on a stable (and motionless) surface, the laser will
continue to try to find level. If the beam will not stop moving, try
placing the laser on a more stable surface. Also, try to make
sure that the surface is relatively flat and level, so that the laser
is stable.