Tabla de contenido
Idiomas disponibles
Idiomas disponibles
E
12.
If your measurement is greater than the Allowable
Distance Between P1 & P3 or P2 & P4 for the
corresponding Distance Between Walls in the following
table, the laser must be serviced at an authorized service
center.
Distance
Between Walls
30' (9m)
40' (12m)
50' (15m)
Horizontal Beam Accuracy
Checking the horizontal pitch calibration of the laser requires
a single wall at least 30' (9m) long. It is important to conduct
a calibration check using a distance no shorter than the distance
of the applications for which the tool will be used.
1.
Place the laser on a tripod facing the corner of a room
(Figure
).
E 1
2.
Move the Power/Transport Lock switch to the right (Figure
) to turn the laser ON in self-leveling mode and
A 3
display the horizontal and vertical beams.
3.
Aim the vertical beam at a corner of the room.
4.
Where the horizontal beam crosses the center of the
adjacent wall, mark P1.
5.
Turn the laser so the vertical beam crosses P1
(Figure
).
E 2
6.
Where the horizontal beam crosses the vertical beam,
mark P2.
7.
Turn the laser so the vertical beam is aimed at the second
corner (Figure
E 3
8.
Where the horizontal beam is vertically in line with P1 and
P2, mark P3.
9.
Measure the vertical distance between the highest and
lowest points (between P1, P2, and/or P3).
12
Allowable Distance
Between P1 & P3 or P2 & P4
1/8" (2.5mm)
5/32" (3.4mm)
3/16" (4.2mm)
).
10.
If your measurement is greater than the Allowable
Distance Between Highest & Lowest Points for the
corresponding Distance Between Walls in the following
table, the laser must be serviced at an authorized service
center.
Distance Between
Walls
30' (9m)
40' (12m)
50' (15m)
Vertical Beam Accuracy
Checking the vertical (plumb) calibration of the laser can be
most accurately done when there is a substantial amount of
vertical height available, ideally 30' (9m), with one person on
the floor positioning the laser and another person near a ceiling
to mark the position of the beam. It is important to conduct
a calibration check using a distance no shorter than the distance
of the applications for which the tool will be used.
1.
Place the laser at least 3.28 ft (1.0m) from a door jamb
(Figure
).
F 1
2.
Move the Power/Transport Lock switch to the right (Figure
) to turn the laser ON in self-leveling mode and
A 3
display the horizontal and vertical beams.
3.
Aim the vertical laser beam toward the door jamb.
4.
Along the bottom of the laser beam, mark three locations
,
, and
; where
a
b
c
5.
Where the top of the laser beam appears at the top of the
door jamb, mark
.
e
6.
Move the laser to the opposite side of the door jamb
(Figure
).
F 2
7.
Align the bottom of the laser beam with
8.
Where the top of the laser beam appears at the top of the
door jamb, mark
.
f
9.
Measure the distance between
Allowable Distance Between
Highest & Lowest Points
7/32" (5.0mm)
9/32" (6.7mm)
11/32" (8.4mm)
is midway between
and
b
a
,
, and
a
b
and
.
e
f
.
c
.
c
Tabla de contenido
