Safety Regulations; Technical Specifications - Pinnacle Protemp PT-515-120 Manual Del Usuario E Instrucciones De Operación

Introduction
To get the most out of your new fan heater, please read
through these instructions and the attached safety
regulations before use. Please also save the instructions
in case you need to remind yourself of the fan heater's
functions at a later date.
Thermostat Instructions
- At first turn the thermostat to "Max" and let the heater
operate with full power input. When the room
temperature reaches the required value, turn the
thermostat counterclockwise until it switches off.
- The thermostat will then switch on and off automatically
to control the room temperature according to the preset
value and to keep the room temperature constant.
- When using the heater for the first time, you may notice
a slight emission of smoke. This is quite normal and it
stops after a short time. The heating element is made of
steel and was coated with a layer of protective oil
during production. The smoke is caused by the leftover
oil as it is heated.
Function Selector Dial
with power settings
Figure 1. Fan Heater Dials

Technical Specifications

Model
PT-515-120
PT-53-240
PT-015-120
PT-03-240
© 2012, Pinnacle Products International, Inc.
Thermostat Dial
Type Voltage / Hz
Turbo 120VAC~60Hz
Turbo 208-240VAC~60Hz
Industrial 120VAC~60Hz
Industrial 208-240VAC~60Hz
Specifications subject to change without notice

Safety Regulations

- Do not place the fan heater immediately under a wall
outlet.
- Do not connect the fan heater using an on/off timer or
other equipment which can automatically switch the
device on.
- The fan heater must not be placed in rooms where
flammable liquids or gases are used or stored.
- If an extension cable is used, it must be as short as
possible and must always be fully extended.
- Children should be supervised to ensure that they do
not play with the appliance. The appliance in not
intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack
of experience and knowledge. If the appliance is
damaged, discontinue use.
- Do not place the appliance on moving vehicles or
somewhere it may easily tip over.
- Use the appliance in places with good air ventilation, do
not position it near a wall or corner.
- A separate circuit serving only this appliance must be
provided. Keep the power cable far enough from the
hot air outlet.
- If the supply cable is damaged, it must be replaced by
the manufacturer or service agent or a similarly
qualified person in order to avoid a hazard.
- You must not connect other appliances to the same
electrical outlet as the fan heater.
- The fan heater is not suitable for use outdoors in damp
weather, in bathrooms or in other wet or damp
environments.
- Do not cover the fan heater.
- Please note that the fan heater can become very hot
and should, therefore, be placed at a safe distance from
flammable objects such as furniture, curtains and simi-
lar objects.
- Altering the cord in any way will void the warranty.
Max. Power
Rating
5,100 BTU
10,200 BTU
5,100 BTU
10,200 BTU
6
Electric Fan Heater User's Manual
NEVER LEAVE HEATER
UNATTENDED WHILE
CONNECTED TO A POWER
SOURCE
Settings (W/BTU)
1 (1,500 W)
1 (5,100 BTU)
1 (3,000 W)
1 (10,200 BTU)
3 (500 - 1,000 - 1,500 W)
3 (1,700 - 3,400 - 5,100 BTU)
2 (1,500 - 3,000 W)
2 (5,100 - 10,200 BTU)