Uline H-3619 Manual De Usuario página 3

ASSEMBLING CABINET
1. Place the two back panels (1) on a protected surface.
The flanges should be facing upward. Overlap the
back panels, aligning the holes. Bolt the panels
together using 4 bolts and 4 nuts. (See Figure 1)
Flanges
2. Attach the left side panel (2) to the back panels by
placing the flange around the back and bolting
the back and sides together. Be sure that the shelf supports on all shelf adjustment strips point up on
both back and side panels. (See Figure 2)
PAGE 3 OF 15
ASSEMBLY INSTRUCTIONS
1
Figure 1
2
Figure 2
3. Attach the top (8) to the unit by sliding the outer
flange over the back of the unit and the side flange
to the side panel. The threaded studs should go
through the holes in the top flange of the side and
fasten with three nuts. Attach the back to the top
using 4 bolts and 4 nuts. (See Figure 3)
Threaded studs go
through the holes
in the flange at
the top of the side.
4. Attach the right side (3) to the back in the same
manner as done in step 2, again making sure that
the flange is around the back and that the shelf
supports on the shelf adjustment strips are pointed
in the same direction as those on the back and left
side. Push the side panel up so the studs in the top
go through the holes in the top flange of the side
and fasten with three nuts. (See Figure 4)
Flanges on the top
go over the back
and sides.
8
Figure 3
3
Figure 4
0321 IH-3619