Stroller Assembly; Canopy Installation - UPPAbaby VISTA Manual Del Usuario

STROLLER ASSEMBLY
UNFOLD STROLLER
STEP 1 : Pull latch back with your thumb to release
locking mechanism.
INSTALL/REMOVE WHEELS
TO INSTALL THE BACK WHEELS:
While pressing in the hubcap of
the wheel, slide the wheel into
the axle until it locks into place.
TO INSERT THE FRONT WHEELS:
TO REMOVE THE BACK WHEELS:
Slide each front wheel into the
Push the hubcap in and pull the
housing until it locks.
wheel out.
BASSINET
STORAGE BAG
UPPAbaby VISTA Instruction Manual
STEP 2: Pull the handle upward until the frame locks
open as shown.
TO REMOVE THE FRONT WHEELS:
Slide plastic lever in direction
indicated on button and pull wheel
out from frame.
6
STROLLER ASSEMBLY
ATTACH THE SEAT
STEP 1: Insert the posts on the sides of the seat into
the slots of the frame. Push until you hear it "click"
on both sides.
STEP 2: Pull up on seat to be sure it is properly
attached to the frame.
NOTE: Seat can attach in either forward or rear-facing direction.
ATTACH/REMOVE
THE BUMPER BAR
STEP 1: Insert metal posts into bumper bar
attachment slots found on both sides of seat.
STEP 2: To remove, press button at bottom of plastic
housing and lift bumper bar out.
WARNING: Bumper bar must
be attached at all times!
STEP 3: To remove, simultaneously push down both
release buttons and lift the seat from the frame
CANOPY INSTALLATION
STEP 1: Pull canopy fabric over seat back.
STEP 2: Snap each side of canopy attachment to seat
frame above plastic ring.
NOTE: Canopy height is adjustable.
7
.
ENGLISH