Fitting The Clutch Head To The Wheel - Hauck DRYK DUO Manual De Instrucciones

3.1. FITTING THE CLUTCH HEAD TO THE WHEEL

G
H
I
I
- GB 12 -
1
REMOVE CLUTCH HEAD
Press down the safety bracket
at the front end of the drawbar. By
folding the handle away, you can pull
out the safety pin [H].
Then release the clutch head
the drawbar.
2
REMOVE REAR AXLE
Undo the rear axle of your bicycle
and pull it out. Please also take note
of the user manual of your bike.
Then slide the clutch head
axle.
3
FIX CLUTCH HEAD
Tighten the rear axle again. Make
sure that the system is completely
closed and that the axle cannot
come loose.
If you use the bike trailer frequent-
ly, you can leave the clutch head
attached to the axle. This makes
it easier to attach and detach the
trailer.
[G]
[I] from
[I] on the