Inside View; Secure Cover And Bottom Rails - ShelterLogic 70401 Instrucciones De Ensamblaje

c. When properly installed, the doors will wrap around the frame and the web-
bing will be exposed to the inside of the building as shown in Detail H and i.
D. tighten the panel by inserting the "S" Hooks into the holes in the corner
legs, pulling tightly and tying off as shown. See Detail j. Repeat this step for
the other panel door.
COVER
WEBBINg

INSIDE VIEW

WEBBINg, RATCHET AND
"S" HOOK CONNECTOR TO FRAME
FRAME FOOT
5. SECURE COVER AND BOTTOM CROSS RAILS:
A. After pulling the cover over frame, the welded-in straps (webbing)
should be at the front and back corners of the shelter. Adjust the cover
so it sits evenly on the frame.
NOTE: The pocket at the bottom, along the sides of the cover, should
be on the inside as shown in Detail K.
B. Insert the (4) "S" Hooks with ratchet clamps into outside frame foot
holes as shown in Detail L. Tighten and adjust as necessary. The fit
should be snug.
c. inside, assemble the cross-rail poles at one side, loosely attach the
corner brackets, then slide the poles through the fabric pockets at each
leg. Repeat this on the other side. See Detail M.
Detail K
Detail H
WEBBINg
WEBBINg
FRAME
POLES
POCKET
800178
and
800179
CROSS RAILS
AND POCKETS
SIDE VIEW
FRAME
POLES
WEBBINg-OUTSIDE VIEW
"S" HOOK HOLE
The ratchet should be checked monthly to make sure the
cover is secure.
Page 7
Detail g
CROSS POLE
3-WAY SIDE
CONNECTOR
zIPPER
WEBBINg
POCKET
WEBBINg
AND RATCHET
Detail I
Detail J
Detail L
WEBBINg
INTERIOR
WEBBINg
05-70401-5-OD