Attach Uprights And Attach Feet; Anchor Shelter; Install Zipper Door And Back Panel - ShelterLogic 70401 Instrucciones De Ensamblaje

2. ATTACH UPRIGHTS AND ATTACH FEET:

Assemble corner leg bends to vertical poles then to roof frame as shown in Detail c. Repeat for opposite side.
NOTE: No bolts are required for these connections.
800374
800361

3. ANCHOR SHELTER:

A. Anchors must be placed inside of shelter. Place the frame in its final position. Check that it measures 6' in
width and length. See Detail D. Screw the (4) 15" temporary augers into the ground at the four corners. Use a
post hole digger/shovel to loosen ground if it is too hard to screw auger in. fill hole with cement if preferred.
NOTE: 15" Augers are for temporary use only! We recommend 30" Augers be used, 4 minimum for use in a
permanent installation.
b. be sure to thread cable through the hole in the corner leg bend, through the eye of the anchor, and secure
with cable and clamp as shown in Detail e.
6'

4. INSTALL ZIPPER DOOR AND BACK PANEL:

A. Starting from the inside peak, remove the top pole from the 3-way top
connector. Place exposed webbing at the top of the zipper door panel over
the 3-way connector and under the cross pole as shown in Detail f.
Reinsert the top pole into the connector.
b. At each corner, remove the cross poles from the 3-way connectors. Place
the webbing and cover over and fold the fabric around to the inside of the
connector. Put the 3-way socket through the opening in the fabric as shown
in Detail G. Reinsert the cross pole into the connectors.
05-70401-5-OD
6'
Detail D
Detail C
Detail E
Page 6
Detail F
3-WAY TOP
CONNECTOR
WEBBINg
TOP
POLE