KMR 3522 Manual Del Usuario página 4

4 I English
1 TECHNICAL DATA
Type
Dimensions mm
Weight kg (without fasteners)
Single sequential actuation
Recommended operating pressure
range
Maximun permissible operating
pressure
Air consumption per driving
operation
Magazine capacity No. of fasteners
Penetration depth setting
Fastener: Plastic bound nail
Nail length mm
Nail shank Ø mm
Recommended lubricant
1 litre special oil. Code No.
250 cm3 grasa especial. Code No.
2 NOISE / VIBRATION INFORMATION
Noise characteristic values *
A-weighted single-event emission
sound pressure level at work
station L pA, 1s
A-weighted sound power level
L WA, 1s, d
Vibration characteristic values **
Weighted r.m.s.-acceleration (a)
The noise level when working can exceed 85
dB (A). Wear ear protection!Measured
* values determined according to EN
12549:1999.
** Measured values determined according to
ISO 8662-11:1999.
3 SUPPLIED WITH
1
Anchoring nailer
1
Tool use and safety instructions
1 Technical data sheet
KMR
4
3522
Only those fasteners specified under technical data
(see 1) may be used.
345/525
When filling the magazine, hold the tool so that the
4.1 kg
muzzle is not pointing towards own body or towards
any other person.
Do not load the tool with fasteners with the safety
5-8.5 bar/
yoke or trigger depressed.
0.5-0.85 MPa
Pull pusher back until it has reached the point where
8.5 bar/
there is noticeable resistance and it catches. Introduce
0.85 MPa
2 nail strips into the magazine, unlock pusher and lead
2.8 l at 6
it against the nail strip. Make sure that the nail strips
bar / 0.6 MPa
lie correctly in the magazine and that the pusher nose
reaches over the head of the last nail. Never should the
50
pusher be allowed to snap forward in a magazine
no
which is half or totally empty. Always guide it by hand
up to the nail strip or stop.
40-60
4.0
5
Having checked that the fastener driving tool is
9 4420
functioning correctly, apply the tool to a work piece
68 3868
and actuate the trigger.
Carefully insert the projecting nail tip into the
appropriate hole in the sheet, press the machine
firmly against the workpiece and pull the trigger
(70 008). Release the trigger after the nailing stroke
3522
and remove the tool.
The tip of the nail must be inserted in the intended
hole. Do not nail directly into sheet.
94 dB(A)
6
107 dB(A)
3.0 m/s2
Suspension
Balancer for 30-55 N (3.0-5.5 kp),
cable travel 2.0 m
FILLING THE MAGAZINE
HANDLING THE TOOL
ACCESSORIES
3522
Code No.
71 3287
28 6478