Technical Data; Noise/Vibration Information; Filling The Magazine - KMR 3722 Manual Del Usuario

4 I English
1

TECHNICAL DATA

Type
Dimensions mm
Weight kg (without fasteners)
Single sequential
Recommended operating pressure
range
Maximun permissible operating
pressure
Air consumption per driving
operation
Magazine capacity. (No. of
fasteners)
Penetration depth setting
Fastener: Plastic bound nail
Nail length mm
Nail shank Ø mm
Recommended lubricant
1 litre special oil. Code No.
250 cm3 grasa especial. Code No.
2

NOISE/VIBRATION INFORMATION

Noise characteristic values *
A-weighted single-event emission
sound pressure level at work
station L pA, 1s
A-weighted sound power level L
WA, 1s, d
Vibration characteristic values **
Weighted r.m.s.-acceleration (a)
The noise level when working can exceed 85
dB (A). Wear ear protection!
* Measured values determined according to
EN 12549:1999.
** Measured values determined according to
ISO 8662-11:1999.
3 SUPLIED WITH
1 Anchoring Nailer
1 Tool use and safety instructions
1 Technical data sheet
1 Transport case
KMR
4
3722
Only those fasteners specified under technical data
(see 1) may be used.
366/352
When filling the magazine, hold the tool so that the
2.55 kg
muzzle is not pointing towards own body or towards
any other person.
Do not load the tool with fasteners with the safety
5 - 8 bar/
yoke or trigger depressed.
0.5 - 0.8 MPa
Pull pusher back until it has reached the point where
8.0 bar /
there is noticeable resistance and it catches. Introduce
0.80 MPa
1 nail strip into the magazine, unlock pusher and lead
1.73 l at 6 bar /
it against the nail strip. Make sure that the nail strip
0.6 MPa
lie correctly in the magazine and that the pusher nose
reaches over the head of the last nail. Never should
the pusher be allowed to snap forward in a magazine
25
which is half or totally empty. Always guide it by hand
no
up to the nail strip or stop.
40-50
5
5.5
Having checked that the fastener driving tool is
functioning correctly, apply the tool to a work piece
9 4420
and actuate the trigger.
68 3868
Carefully insert the projecting nail tip into the
appropriate hole in the sheet, press the machine
firmly against the workpiece and pull the trigger
(215). Release the trigger after the nailing stroke and
remove the tool.
3722
The tip of the nail must be inserted in the intended
hole. Do not nail directly into sheet.
91 dB(A)
6
104 dB(A)
Balancer for 20-30 N (2.0-3.0 kp),
4.41 m/s2
cable travel 2.0 m (6.5 ft)

FILLING THE MAGAZINE

HANDLING THE TOOL
ACCESSORIES
3722
Code No.
40 3407