Ecco 12+ Pro Vantage Serie Manual Del Usuario página 6

12+ Pro Vantage™ Lightbar
12+ Pro Vantage™ Lightbar
STTs OPTIONAL
STTs OPTIONAL
Optional Stop/Tail/Turn Optional Stop/Tail/Turn
(STT) Cable
(STT) Cable
BROWN (TAIL) BROWN (TAIL)
YELLOW (LEFT TURN)
YELLOW (LEFT TURN)
GREEN (RIGHT TURN)
GREEN (RIGHT TURN)
RED (STOP) RED (STOP)
WHITE (STT GROUND) WHITE (STT GROUND)
Maintenance
Occasional cleaning of the lenses will ensure optimum light output. Take care when cleaning
lenses – although tough, polycarbonate scratches easily. Clean the lens and base with soap
and water or a lens polish using a soft cloth. Do not use solvents as they may damage the
polycarbonate. Do not subject the lightbar to high-pressure washers or automatic car washers.
Lens Removal and Installation
1. Remove the screws from the lenses. Starting at one edge, pull the lens off.
2. Carefully lift the lens off the seal – choose a suitable location to temporarily store the lens so
as to not scratch the surface.
3. When reinstalling, gently apply pressure around the lens taking care not to damage the
seal. Replace the screws.
Warning LED Modules (EZ1203X, EZ1206XX)
The LED lightheads have been designed to ensure long service life using high performance
LEDs. The modules are low profile units that have a high intensity output with low current draw.
The LED lightheads can be mounted in the front, rear and corners of the lightbar.
SERIAL INTERFACE BOX (EZMATSIB)
Power/Ground Cable
Power/Ground Cable
BLACK BLACK
NOTE: GREEN AND YELLOW
NOTE: GREEN AND YELLOW
WIRE FUNCTIONS ARE
WIRE FUNCTIONS ARE
SWAPPED IN LIGHTBARS WITH
RED
SWAPPED IN LIGHTBARS WITH RED
PASSENGER SIDE CABLE EXIT.
PASSENGER SIDE CABLE EXIT.
USE THE RED WIRE IN 3-WIRE See Fuse
USE THE RED WIRE IN 3-WIRE
See Fuse
SYSTEMS ONLY
Recommendations
SYSTEMS ONLY.
Recommendations on
Page 1. on Page 1
SIB
4-Pin Connector
4-Pin Cable
1-2 A
IGNITION
IGNITION
SWITCH SWITCH
GRAY/BLACK - Ignition Wire
GRAY/BLK - Ignition Wire
YELLOW - Left Alley Yellow - Left Alley
Purple - Right Alley PURPLE - Right Alley
GRAY - Worklights Gray - Worklights
ORG/BLK - Takedown Lights
ORANGE/BLACK - Takedown Lights
Pink - Arrowstik Left PINK - Arrowstik Left
ORANGE - Arrowstik Right Orange - Arrowstick Right
YLW/BLK - Arrowstik Flash
YELLOW/BLACK - Arrowstik Flash
GREEN/BLACK - Level 1
GRN/BLK - Level 1
WHITE/BLACK - Level 2 WHT/BLK - Level 2
RED/BLACK - Level 3
RED/BLK - Level 3
BLUE/BLACK - Rear Cut
BLU/BLK - Rear Cut
PUR/BLK - Front Cut
PURPLE/BLACK - Front Cut
Brown - Left Cut
BROWN - Left Cut
GREEN - Cruise
Green - Cruise
Blue - Dim
BLUE - Dim
BLU/WHT - Program Patterns
BLUE/WHITE - Program Patterns
WHITE - Arrowstik Pattern White - Arrowstik Pattern
1 A
NOTE: Not all SIB input wires
NOTE: Not all SIB input wires
are used.
are used.
Page 6 of 14