Cleaning And Maintenance; General Cleaning; Removing Obstructions And Blockages; Clean The Air Filter - Grizzly Tools BLSB 3030 Traducción Del Manual De Instrucciones Original

Cleaning and
maintenance
Disconnect the spark plug terminal
before carrying out any work on
the equipment.
Leave all work not described in
this manual to our Service Cen-
tre. Only use original parts.
Before every use, check the leaf blower
for obvious deficiencies, such as loose,
worn or damaged parts and for correct
seating of the parts. Replace damaged
parts. Check the bag regularly for wear
and tear.
Carry out the following maintenance and
cleaning work regularly. By this means, a
long and reliable life is guaranteed.

General cleaning

Clean the device in each case
immediately after working, since
otherwise mud with leaf residues
hardens and sets and can pos-
sibly no longer be removed without
dismantling the motor casing.
Such cleaning work is not cov-
ered by the guarantee.
Do not employ any cleaning agents
or solvents. They can irreparably
damage the device. Chemical sub-
stances can attack the plastic parts
of the device.
• Clean the device casing, the tube and
the ventilation slots regularly with a
soft brush or a cloth. Never clean the
device under running water.
• Take off the collection bag after finish-
ing work, turn it inside out and brush it
thoroughly. In this way, you avoid the
generation of mold and unpleasant
odours.
• Free the outlet area from possible
shredded residues.
Removing obstructions
and blockages
Leaves and fresh plant cuttings may ob-
struct the device
Cleaning the impeller:
1. Loosen the fixing bolt (6) of the intake
cover (7) and open the intake cover.
2. Carefully remove debris or obstruc-
tions from the impeller (9).
3. Check that the impeller rotates easily
and is in perfect condition. Replace a
defective impeller at our service centre.
4. Refasten the intake cover.
Cleaning the discharge chute:
1. Remove the collection bag (30) or the
blower pipe (25).
2. Clean the outer area of the device dis-
charge chute (10).
3. Remove dirt remnants on the inside of
the discharge chute with a brush (e.g.
bottle brush). Remove bulky items
with a blunt and dull tool.
Cleaning the suction pipe
1. Loosen the fixing screws (33) and re-
move the suction pipe (23).
2. Tap the suction pipe and clean out the
inside if necessary.

Clean the Air Filter

Never operate the equipment
without an air filter, otherwise dust
and dirt will get into the motor and
result in damage to the machine.
Keep the air filter clean.
GB
99