Kunft KBIO3954 Manual De Instrucciones página 14

Insert the oven into the cabinet by pushing it forward. Open the oven
door and insert 2 screws in the holes located on the oven frame.
When the product frame touches the wooden surface of cabinet,
tighten the screws.
If the oven is installed under a hob, the distance between the
worktop and the top panel of the oven must be at least 50 mm and
the distance between the worktop and the top of control panel must
be at least 25 mm.
The dimensions and materials of the cabinet in which the cooker is
to be installed must be resistant to high temperatures. In a correct
installation, please avoid any contact with electrical or insulating
parts. The insulation parts must be placed in such a way that
they cannot be removed regardless of the used tool. Installing
the appliance near a refrigerator or freezer is not recommended.
The performance of the above devices will be affected by the heat
emanating from the cooker.
After removing the cooker from the package, check it for damage.
If any damage is found, do not use the appliance and contact the
authorized service centre immediately.
Wiring and safety of built-in oven
The instructions given below must be strictly followed during wiring:
• The earthing cable must be connected via the screw with the
earthing mark (
figure 2. If there is no earthed outlet conforming to regulations in the
installation environment, call the Authorized Service immediately.
• The earthed outlet must be in the appliance's immediate vicinity.
Never use an extension cord.
• The supply cable should not contact the product's hot surface.
• In case of any damage to the supply cable, make sure to call the
Authorized Service, as the cable must be replaced by them.
• Wiring of the appliance must be performed by the Authorized
Service and a H05VV-F type supply cable must be used.
• Faulty wiring may damage the appliance, which will not be covered
by the unit's warranty.
• The appliance is designed to connect to 220-240 V~ power. If your
electricity is different than the value given above, call the Authorized
Service immediately.
The Manufacturer shall not be responsible for any kind of damage
and loss whatsoever arising from any non-compliance with the safety
standards!
Forno-KBIO3954-Kunft-Manual-5.indd 14
). Supply cable connection must be as shown in
14
18/05/16 16:31