Tabla de contenido
Idiomas disponibles
Idiomas disponibles
BEFORE CALLING FOR SERVICE (continued)
........
!
!t!
Water in the washer drains
Drain hose is kinked, pinched, or clogged.
Make sure the drain hose is free of clogs,
slowly or not at all, or the
kinks, etc., and isnot pinched behind or
display shows:
under the washer.
I
mF I
Drain discharge is more than 96 inches
Adjust or repair drain. Maximum drain
above bottom of washer,
height is 96 inches (8 ft.)
The display shows:
The washer has detected an out of
If the washer detects a load that is too far
balance load.
out of balance to spin, it will display this
The display shows:
The display shows:
The display shows:
CC
The display shows:
I
FIZIC,;
I
The display shows:
The display shows:
|
|
The display shows:
| L
If the uE rebalance (see above) is not
successful, this error will be displayed.
The load is too small.
Heavy articles are mixed with lighter
items.
The load is out of balance.
Control error.
Water level is too high due to a faulty
water valve.
The water level sensor is not working
correctly.
A motor error has occurred,
Clutch error.
Foreign objects, such as coins, pins, clips,
etc., caught between the wash plate and
the inner basket.
code while it is attempting
to rebalance
the load. The washer will add water and
try to redistribute the load automatically.
This display is for your information
only,
and no action is required.
The automatic attempt to rebalance the load
was not successful.Thecycle has been paused
to allow the load to be manually adjusted.
Small loads may need additional items to be
added to allow the washer to balance the loads.
The load may have heavy items loaded with
lighter items. Always try to wash articles of
somewhat similar weight to allow the washer
to evenly distribute the weight of the load for
spinning.
Manually redistribute the load if articles have
become tangled preventing the automatic
distribution from working properly.
Unplug the washer and wait 60 seconds.
Reconnect power and try again. If the error
reappears, call for service.
Close the water faucets, unplug the washer,
and call for service.
Close the water faucets, unplug the washer,
and call for service.
Allow the washer to stand for 30 minutes
and then restart the cycle. If the LE error
code persists, call for service.
Mechanical failure.
Unplug the washer and call for service.
Turn off the washer and then press the
Power button. Pressthe spin speed button
without selecting a cycle to drain and spin
the load.
When the spin is complete, remove the
clothes and then find and remove any
objects caught in the wash plate.
Always check pockets, etc., before washing
to prevent error codes or damage to the
washer or clothing.
32
Capítulos
Tabla de contenido
