Switching Wlan On And Off - SMA SUNNY TRIPOWER CORE1-US Serie Instrucciones De Uso

SMA Solar Technology AG
Activating WPS function for automatic connection to a network
Requirements:
☐ WLAN must be activated in the product.
☐ WPS must be activated on the router.
Procedure:
1. Activate the user interface (see Section 4.1, page 19).
2. Log in as Installer.
3. Start the installation assistant (see Section 4.6, page 27).
4. Select Network configuration.
5. Select WPS for WLAN network button in the WLAN tab.
6. Select Activate WPS.
7. Select Save and next and exit the installation assistant.
☑ The WPS function is activated and the automatic connection to the network can be
established.
Activating the WPS function for direct connection to the end device.
• Activate the WPS function on the inverter. To do this, tap twice in succession on the enclosure
lid of the DC-Connection Unit next to the LEDs.
☑ The blue LED flashes quickly for approx. two minutes. The WPS function is active during
this time.
4.8

Switching WLAN On and Off

The inverter is equipped with an activated WLAN interface as standard. If you do not want to use
WLAN, you can switch the WLAN function off and switch it on again whenever needed. In doing
so, you can switch the WLAN direct connection and the WLAN connection in the local network on
independently of each other.
Switching on the WLAN function only possible via Ethernet connection
If you switch off both the WLAN function for the direct connection and for the connection in
the local network, access to the inverter user interface and therefore reactivation of the WLAN
interface is only possible via an Ethernet connection.
The basic procedure for changing operating parameters is explained in another section (see
Section 4.11 "Changing Operating Parameters", page 31).
Switching WLAN Off
If you would like to switch the WLAN function off completely, you must switch off both the direct
connection and the connection in the local network.
Procedure:
• To switch off the direct connection in the parameter group PV system communication >
WLAN, select the parameter Soft-access-point is turned on and set this to No.
User Manual STP33-62-US-41-BA-en_es-10
4 Operation
29