ICY BOX IB-121CL-6G Manual De Instrucciones página 5

http://www.icybox.de http://www.icybox.de
4.3 HDD Initialization
A new HDD must first be initialized, partitioned and formatted by the operation system to be displayed
by the system.
4.4 2bay docking function
The IB-121CL-6G allows you to run 2 different HDDs regardless their brands, models, or capacities via
one USB connection. Just connect the IB-121CL-6G to the computer and the HDDs will be detected as
independent drives. Thanks the hot-plug supporting you can exchange the HDDs by running system.
4.5 HDD cloning-function
- Before the cloning process, please remove the USB cable from the device.
- Insert the source drive into slot HDD1 (source) and the target drive to slot HDD2 (target).
- Press Power button to power on the device. Power LED will be lit in blue as PC mode.
- Press and hold the MODE button for 3 seconds to change to clone mode. Power LED will
be changed from Blue to Red.
- Press the Start button. Both HDD1 and HDD2 LED will start to blink. The first LED of
progress indicator (25%) will start to blink as well. The cloning is in process.
- When the status indicator reaches 100% and stops blinking, your cloning process is completed.
Press power button to turn off the power then remove the HDDs.
4.6 Advices to the cloning-function
The clone function creates an identical copy of your hard drive – no need to connect to any
computer. You can copy a bootable system disk without additional software or professional
skills.
- Since the cloning process copies every single byte of the source HDD the process may take
several hours depending on the HDD capacity.
- After the cloning process is completed, in some cases the computer may not be able to identify
both drives since they are assigned to the same drive letter. To separate the drives, you must assign
one drive to a new drive letter under "disk management" (Windows).
- If only one drive is plugged into HDD1 (source), there will be no action when you press the
start button.
- The target HDD (HDD2) must be of the same size or bigger than the source HDD (HDD1).
- If the targets drive (HDD2) is smaller than the source drive (HDD1), after pressing the start button,
both HDD1 and HDD2 LED will blink in high frequency. Please press the power button to turn off
the power and remove the HDDs
- You may create a new volume with the remaining space on the target HDD after cloning.
IB-121CL-6G
5 5