Cleaning And Maintenance - Hkoenig expro980 Manual De Instrucciones

8. Cup volume adjustment: Press and hold Single cup button and Double cup button at the same
time, the machine enters customized cup volume status (single indicator and double indicator flash
at the same time), press single button at this time (single indicator flashes, double indicator
illuminates) to memorize single cup volume while start to dispense hot water, press Single cup
button again (single indicator illuminates) to stop dispensing water and finish memorizing. After the
memorization is completed, the machine resumes customized cup volume status; Set double cup
volume in same method as above.（For single cup amount of water is 20-60ml, double cup is
60-100ml）
）
Note:
1 Steam knob shall be in off position during preheating when brewing coffee or Making hot
water.
2) Single cup or double cup coffee can be brewed only after finishing preheating.
）
3 You can press single button or double button to stop during coffee brewing.
）
4 When water tank lacks of water( less than MIN level), the unit will alarm, indicator flashes, after
refilling water, it will turn to normal condition.
）
5 If you want to return cup volume to the defaulted factory setting, just press and hold the
corresponding cup button for 5s while button indicator flashes twice.
6) After finish frothing milk, the steam pipe should be wiped with a moist cloth in time, and steam
shall be produced for a length of time to prevent the milk from clogging the steam nozzle. In case
of steam pipe blockage, clean needle can be used to dredge steam pipe hole.
7) After finish making steam, hot water and brewing coffee functions cannot be performed during
machine cooling stage until machine enters standby mode.
8) When the red float of the drip tray rises above the drip plate, it means that the drip tray is near
full water, please pour water in time.

CLEANING AND MAINTENANCE

Tip: The grinder of this coffee machine is detachable. The
detailed dis-assembly method is shown below:
Dis-assembly method: Press release button as shown, turn
the adjustment knob to the maximum setting, and then turn
it in the dis-assembly direction shown in the figure to
remove the grinder vertically.
Assembly method: Align the bump position of grinder with
the slot position of unit, attach grinder into unit vertically.
Turn the adjustment knob to the finest setting and turn the
grinder in the assembly direction until a click sound is
heard.