RISCO Group LuNAR DT AM Grade 3 Guia De Instalacion página 27

Tabla de contenido
1
2
16
ON
Terminal Blocks
TERMINAL BLOCK 1
DESCRIPTION
+12V (RED)
Power supply positive (+) input voltage
- (BLK)
Common to control panel power supply
BUS (GRN)
Used for data communication with the ProSYS
BUS (YEL)
Used for data communication with the ProSYS
Used to remotely SET/UNSET the detector.
SET
When an activation signal (see RC/SET Activation jumper for settings) is applied to the SET input
of the terminal block:
AM will be disabled (if the AM DIP switch 5 was previously ON)
MW module is enabled (if the Green Line DIP switch 3 was previously ON).
Removing an activation signal will cause a Self Test (if the Remote Self Test DIP switch 4 was
previously OFF).
26
3
4
5
32
ON
ON
ON
OFF
Ind. LuNAR RK200DTG3 Installation Guide
ON
ON
ON
ON
ON
ID
1
2
3
4
5
ID
Tabla de contenido
loading

Tabla de contenido