How To Use - Ryobi EWD-1245 Manual De Utilización

GB
FR D
ASSEMBLY
Rotate latches inward to lock lid in place.
■
Note: For convenience in attaching and removing the
lid, finger holds are provided.
ATTACH HOSE, WANDS AND CLEANING
TOOL (Fig. 6)
Push hose into hose intlet on tank; twist hose to
■
tighten or loosen connection. (See "How to use"
section for proper inlet selection.)
The wands and tools attach to hose in the same
■
manner.
Press squeegee insert firmly into wet/dry nozzle
■
opening (See Fig. 7).
Use squeegee for wet pick-up only.
■
ATTACH DRAIN CAP (Fig. 8)
Screw drain cap (I) onto lower, front of tank as shown.
You can use additional tools and accessories that are not
included.

HOW TO USE

CLEANER DESCRIPTION (Fig. 9)
The assembled Wet/Dry vac will look like the drawing.
Operate cleaner only at voltage specified on rating
label on cleaner lid.
1. ON/OFF switch
2. Cleaner lid
3. Cleaner lid latches
4. Carrying handles
5. Hose inlet
6. Wet/dry selector
7. Caster Support
8. Casters
9. Tank drain cap
10. Cleaner tank
11. Extension tube storage holders
12. Vacuum nozzle
13. Cord hook: loop cord over hook for storage
14. Blower port
15. Crevice tool
16. Wet/Dry nozzle with squeegee insert
E I P NL S DK N FIN
English
SEPARATE WET / DRY TANKS
This feature allows the user to change from wet pick-
■
up to dry pick-up without having to empty the tank or
change filters. Dry debris will collect in the inner tank
and wet debris will collect in the outer tank.
Wear ear protection if operating cleaner for a
■
prolonged period of time.
Make sure that the small foam and cartridge filters
■
are in place.
DRY PICK-UP (Fig. 10)
Disconnect cleaner from electrical outlet.
■
With hose removed from cleaner, slide wet/dry
■
selector (A) to expose "Dry tank inlet" (B). Selector
will snap into place. Insert hose into "Dry tank inlet".
Attach the desired tool to hose end.
Make sure cleaner lid is locked in place.
■
Plug power cord into a properly grounded outlet and
■
turn cleaner on.
WET PICK-UP (Fig. 11)
Disconnect cleaner from electrical outlet.
■
With hose removed from cleaner, slide wet/dry
■
selector (A) to expose "Wet tank inlet" (C). Selector
will snap into place. Insert hose into "Wet tank inlet".
Attach desired tool (with squeegee if available) to
■
hose end.
Make sure cleaner lid is locked in place.
■
Plug power cord into a pr operly grounded outlet and
■
turn cleaner on.
Do not use cleaner as a pump to clean out
■
clogged drains, sinks, or other plumbing fixtures.
If cleaner will not pick up, check filters.
They may need to be cleaned or replaced.
(See "Maintenance" section.)
SINGLE TANK OPERATION
For picking up very large amounts of debris (either wet
or dry), the cleaner may also be operated without the
inner tank in place.
Disconnect cleaner from electrical outlet.
■
Remove inner tank and set aside.
■
Attach hose to either the wet or dry intake port.
■
Plug power cord into a properly gounded outlet and
turn cleaner on.
When using single tank for dry pick-up, cartridge filter
■
must be in place.
13
GR TR EST LT LV