Solo Port 423 Manual De Instrucciones página 31

Ocultar thumbs Ver también para Port 423:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 50
13. Draining and cleaning the tank
For cleaning purposes, the tank can be fully
drained into a suitable container via the supply
hose.
For this, the engine must be cooled down.
Position the equipment onto a stable higher
support, so that the spray medium can drain into a
suitable container below.
Fig. 10
Above the container, pull the supply hose from the
shut-off valve.
If required, tip the equipment slightly to drain the
tank completely.
Ensure that the spray medium does not run over
the equipment (especially the engine), but drains
directly into the suitable container.
Please obtain the following practical accessories from your SOLO Dealer:
Accessories
14.
Dusting Attachment
ULV-nozzle
Double Nozzle
Deflector
ULV Dosage Selector
Attachment for
Liquid Booster Pump
Extension Tube 60 cm
Allows conversion to dusting unit.
ULV-Nozzle with ULV dosage selector for application of minute
amounts of high concentrated substances (ultra-low volume
application technique), with dosage accuracy.
To broaden spray stream or to treat two rows simultaneously.
Used with standard or diffuser nozzle to achieve wide upward
spray stream to treat underside of foliage.
For application of minute amounts of high concentrated
substances (ultra-low volume application technique), with dosage
accuracy.
Increases formula output and application range.
Multiple Combinations possible with use of Liquid Booster Pump
Draining and cleaning the tank ; Accessories
Dispose of residual spray medium correctly at
disposal sites licensed for specialised waste.
Empty the spray medium tank daily after work and
flush thoroughly with water.
Observe cleaning instructions supplied with the
herbicide/fungicide.
For cleaning, we recommend the SOLO cleaner for
pesticide sprayers that is available in 500 ml
bottles; part no.: 49 00 600.
Occasionally clean the strainer inside the filler
neck, the strainer in the accessory set and all parts
in contact with the medium, with water and a soft
brush.
After cleaning, let the spray medium container dry
in an open state.
Fig. 11
Part No.
49 00 233
49 00 479
49 00 137
49 00 355
49 00 169
49 00 117
49 00 333
ENGLISH 15
Tabla de contenido
loading

Productos relacionados para Solo Port 423

Tabla de contenido