Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Setting Tool
Anchor
Marble
Foam Padding
Wood Screw
Anchor Screw
2. Install the Undercounter Lavatory
Cut out the opening by carefully following the pencil line traced
from the template.
NOTE: The screws and anchors provided should be used on
countertops with a minimum 1" (2.5 cm) thickness. For thinner
countertops, use appropriate anchors and fasteners (not provided).
Do not use the anchors provided when installing the lavatory to a
countertop or console table where anchors are already present.
For Wood Countertops
Mark and pre-drill the wood screw holes at the locations shown
on the template.
Waterproof any exposed areas of wood.
For Marble/Stone Countertops
Position the countertop upside down on foam padding to protect
the surface. Mark and drill 3/8" holes 5/8" (1.6 cm) deep at the
locations shown on the template.
Use a setting tool and hammer to secure the anchors.
For All Installations
If the countertop has not been installed, install it at this time.
Drill the faucet holes according to the faucet installation
instructions.
116108-2-B
Clamp
Apply sealant.
4
Kallista
Tabla de contenido
