Idiomas disponibles
Idiomas disponibles
10
52. Route the fog lamp harness (1) along the cooling fan
assembly (2) and connect the LH fog lamp connector
to the fog lamp.
53. Secure the harness with tie straps as necessary un
der the vehicle, in the wheelhouse and engine com
partment.
54. Position the RF wheelhouse splash shield and install
the twelve pushin retainers (1).
55. Install the wheel
56. Remove the supports and lower the vehicle.
57. Connect the battery negative (2) cable.
58. Configure the vehicle as follows:
a. Log on to https://dealerconnect.chrysler.com.
b. In the "Vehicle Option" screen under the "Global Claims System" category in the "Service" tab, enter the vehicle
VIN and add the sales code LNJ (Fog Lamps) as a "Dealer Installed Option".
c. Confirm that the new sales code has been successfully added to the VIN.
NOTE: With the scan tool connected to both the internet (via Ethernet port or wireless connection) and the
vehicle, follow the steps below:
d. Using the scan tool select the VEHICLE PREPARATION and then select RESTORE VEHICLE CONFIGURA
TION.
e. Follow the step by step instructions on the scan tool to complete the Fog Lamps vehicle configuration.
59. Verify the system operates correctly.
60. Set the fog lamp height as follows:
a. Place the vehicle on a level surface 25 feet from a wall or screen for viewing the fog lamp illumination height.
b. Turn on the ignition switch and the fog lamps.
c. Using the adjustment screw on the back of the fog lamps, adjust to 100 mm (4 in.) below the fog lamp centerline
straight ahead of the lamp.
Feb 11, 2011
www.mopar.com
K6861239
