Lenco CS-420 Manual De Instrucciones página 4

Press the >>| or |<< button briefly to manually tune up/down for your desired radio station step by step.
Press and hold the >>| or |<< button for more than 0.5 seconds to automatically tune up/down for an
available radio station of strong signal.
b) In SD & USB mode:
Press the >>| button briefly to play next track. Press the |<< button briefly to play from the beginning of
the current or previous track.
Press and hold the >>| or |<< button to skip forward or backward, release to resume normal playback.
9. BAND BUTTON
In radio mode, press the BND button briefly to select the radio broadcasting band you would like to
hear. The AM/FM band is toggled cyclically through the tuning bands:
->FM 1-> FM 2 -> FM 3 -> MW 1->MW 2 ->.
10. MODE BUTTON
Press it to select TUNER, USB(after inserting a USB stick), CARD(after inserting a SD card) or AUX
mode.
11. CLOCK BUTTON
Press CLK button briefly to display clock time , radio frequecy or PTY type alternatively. Each
information displays for 5 seconds on display, and then returns to display information before pressing
CLK button.
Press and hold CLK button for more than 1 seconds until the clock time flashes on display. Then you
can adjust HOUR or MINUTE by pressing VOL- or VOL+ button .
12. PTY (PROGRAM TYPE) BUTTON
Press it briefly and repeatedly to select one of the following mode:
-->POP M--> NEWS-->PTY OFF-->
While selecting POP M or NEWS, its selection is implemented by preset buttons (press one of 6
preset buttons briefly and repeatedly to select a PTY TYPE in the preset button).
When selecting a desired PTY TYPE and there are no keys entered for 2 seconds, the selected PTY
TYPE will be searched. During 1 loop, if the selected PTY TYPE is not found, PTY NONE is
displayed, then return to previous normal radio station and PTY icon disappear.
13. TA [TRAFFIC ANNOUNCEMENT] BUTTON
When press the button, it is activated as TA mode on or off.
When TA mode is on(TA is displayed on LCD), it will begin to seek TA station and TA SEEK will be
displayed on LCD for a while.
When traffic announcement is transmitted:
1). If the unit is in SD or USB mode, it will switch to radio mode temporarily.
2). If volume level is below 20, volume level is raised to 20, and returns to its previous mode and volume
level when the traffic announcement is over. If volume is adjusted during traffic announcement, only
the traffic announcement volume is valid.
* TA interruption function:
The current traffic announcement is cancelled by pressing this key. But the TA mode will not be off.
* When TA is on, SEEK, (SCAN), AUTO MEMORY function can be received or saved only when traffic
program identification code has been received.
When TA is ON, traffic program identification code is not received during specified time.
3